QUICK START PROCEDURES
QUICK START PROCEDURES
1. Load the dishwasher. (There's no need to pre-rinse. Simply scrape off large food particles before
you load the dishware.)
2. After you've pushed the baskets back inside the unit, manually rotate the upper and lower spray
arms to be sure they turn freely. Rearrange any item that blocks the wash arms.
3. Make sure there is rinse aid in the dispenser. Add rinse aid, if needed.
4. Add automatic dishwashing detergent and close the dispenser cover. (See "Amount of Dishwashing
Detergent to Use" on the other side of this Quick Start Guide.)
5. Close the door securely. (You should hear it click shut.)
6. Set the Temp boost and Heated dry options as desired.
7. Turn the control knob to the desired program. The dishwasher will start.
ENERGY SAVING TIPS
ENERGY SAVING TIPS
Don't pre-rinse. Simply scrape off large food particles before you load the dishes.
Wash only full loads.
Don't use the Temperature Boost for lightly soiled dishes.
Avoid using Heat dry. (You can speed up the drying process by opening the door slightly to release the moist air.)
COMMONLY ASKED QUESTIONS
COMMONLY ASKED QUESTIONS
1)
Where do I put the prewash detergent?
2)
Where do I put the rinse aid?
3)
Why does my dishwasher run so long?
4)
Why am I getting a white film on my dishes?
5)
Why is there always water left in the bottom of my
machine?
Refer to your Use and Care Guide for additional information.
ANSWERS
ANSWERS
1)
The prewash detergent goes in the small compartment between
the main wash detergent compartment and the rinse aid
dispenser. (See page 4.)
2)
The rinse aid goes into the rinse aid dispenser. (See page 5.)
3)
If the temperature of the water entering your dishwasher is below
120°, the dishwasher runs longer because it heats the water to
the proper temperature for the program selected. Raising your
water heater setting may help shorten the cycle times. If this
doesn't resolve the problem, call the ASKO Advisory Center.
4)
You may be using too much detergent or washing your dishes in
water that is too hot. Try using less detergent and a lower
temperature setting. (See pages 5 and 8.)
5)
It's normal to have some water left in the sump area near the
drain. If the water fills more than the drain area, see page 9 for
possible solutions.
Refer to this page in
the Use & Care Guide.
3, 4
3
5, 6
4, 5
Art. No. 80 730 97
Print Page