Asko D1796FI Installation Instructions Manual - Page 8

Browse online or download pdf Installation Instructions Manual for Dishwasher Asko D1796FI. Asko D1796FI 14 pages. Standard dishwashers
Also for Asko D1796FI: Use And Care Manual (12 pages), Quick Start Manual (2 pages), Installation And Customization (4 pages), Planning And Design Manual (19 pages), Use And Care Manual (12 pages), Planning And Design Manual (15 pages)

Print Page

CONNECTING THE ELECTRIC CABLE

If the cord is not long enough, or if a hard-wire

installation is needed, follow the steps below to

complete the electrical connection.

WARNING! Before starting this procedure, be sure

the power is turned off at the breaker/fuse box.

Connect supply cable with

a UL-listed strain relief

bushing (if nonmetallic

cable is to be used).

Connect branch circuit white

lead to white lead on main

terminal block.

CONNECTING THE WATER SUPPLY

In order to prevent heat damage to the inlet valve, all

solder connections must be made before the water

supply line is connected.

Flush the water supply line prior to connecting it to the

water fill tube.

The unit has a float switch in the base pan to protect

against flooding. If the inlet valve connection is not

seated properly, water may leak into the base pan and

activate the float switch.

It is important that the water supply line and the shut-off

valve have a sufficient flow volume. At last 3 gallons (12

liters) per minute must be able to pass through the

line. The water pressure should be 18-176 psi.

TESTING FOR LEAKS

1. Turn on the water supply and check for leaks.

2. Turn the power on at breaker/fuse box and test the

dishwasher operation by running a Rinse cycle.

(This should take about four minutes.)

3. Turn off the electrical power and check for leaks

ADJUSTING THE LEVELING LEGS

Now that all the connections are made and the machine

is in place under the cabinet, you should make the final

height adjustment.

1. You should set the rear foot first. To do this, use a

screwdriver to rotate the

adjusting screw on the

bottom

front

machine. Turn the screw

clockwise to raise the foot

and anticlockwise to

lower it.

Page 8

the

Connect branch circuit black lead to brown lead on

main terminal block.

Connect ground wire to ground on terminal block.

NOTE:

When doing a hard-wire installation, you must

remove the supplied power cord.

(1) Water supply

(2) Water supply valve

(not supplied)

NOTE:

Be sure to run the PEX tubing through the hole

to sink compartment before moving the

dishwasher into position.

under the dishwasher and sink.

4. Make sure that no kinks have developed in the drain

lines.

If there are no leaks and the dishwasher seems to be

working properly, continue with the installation.

2. Using a 1/2" (12 mm)

wrench, adjust the locking

nuts until the machine is level.

(The machine may have an inclination of 2°

maximum without affecting its performance.)

3. When the feet are properly adjusted, tighten the

locking nuts to the base pan.

NOTE:

When adjusting the unit lower than 33-1/4" (845

mm), the holes on the toe kick will need to be

to be elongated. An accessory toe kick is also

available for this type of installation. Contact

your dealer to order.