Ambiano FPD1000 Instruction Manual - Page 7
Browse online or download pdf Instruction Manual for Food Processor Ambiano FPD1000. Ambiano FPD1000 16 pages. 3.5l die cast aluminium 1000w power
Also for Ambiano FPD1000: Quick Start Manual (2 pages)
Print Page
Mounting Blades on Spindle
An integral part of using your Food Processor effectively is the correct mounting of
the included blades.
fig 5
fig 6
1.
Locate the slots on the chopping or dough blade. (fig 5)
2.
Locate the two corresponding ridges on the spindle. (fig 6)
3.
Feed the spindle up through the blade, ensuring the ridges are aligned properly with
two of the slots. (fig 7)
4.
Once fed through all the way, you must twist the spindle approximately 20 degrees
anti clockwise to lock it in. (fig 8)
WARNING: Take care when handling the blades as they are sharp and could cause injury.
Always hold the blade by the plastic centre.
Mounting Whip & Whisk tool on Spindle
The Whip & Whisk tool is perfect for whipping cream, whisking egg whites to peaks &
emulsifying eggs for mayonnaise
fig 9
fig 10
1.
Locate the slots on the whip & whisk tool. (fig 9)
2.
Locate the two corresponding ridges on the spindle. (fig 10)
3.
Feed the spindle up through the whip & whisk tool, ensuring the ridges are aligned
properly with two of the slots. (fig 11)
4.
Once fed through all the way, you must twist the spindle approximately 20 degrees
anti-clockwise to lock it in. (fig 12)
AFTER SALES SUPPORT
11
1300 663 907
AUS
fig 7
fig 8
fig 11
fig 12
MODEL: FPD1000 PRODUCT CODE: 9748 07/2019
.
Mounting Discs on Disc Adaptor
Mount the processing discs in the disc adaptor before assembling in the Food Processor.
Do not mount the discs with the chopping or dough blade attached.
fig 13
fig 14
1.
Place the disc adaptor on a flat surface. (fig 13)
2.
Carefully place the chosen processing disc into the adaptor, aligning the tabs. (fig 14)
3.
The processing disc should sit flat in the adaptor. (fig 15)
4.
The assembled processing disc can then be mounted to the spindle in the bowl. (fig
16). See instructions below on how to mount the spindle.
NOTE: Both the slicing and grating discs are double sided, make sure you check which
side you need to use before mounting.
Mounting the Spindle in the Bowl
All functions of the Food Processor require the spindle to be mounted correctly.
fig 17
fig 18
1.
The underside of the spindle (fig 17) has a gear mould that corresponds with the
centre post in the bowl. (fig 18)
2.
To mount the spindle, place it on top of the securing post. (fig 19)
3.
The spindle should sit firmly on the securing post. (fig 20)
NOTE: Mount the spindle without the blade attached when using the processing discs.
AFTER SALES SUPPORT
12
1300 663 907
.
AUS
fig 15
fig 16
fig 19
fig 20
MODEL: FPD1000 PRODUCT CODE: 9748 07/2019