D&R Mic-Amp User Manual - Page 3
Browse online or download pdf User Manual for Amplifier D&R Mic-Amp. D&R Mic-Amp 9 pages. D&r two channel pre-amp user manual
Print PagePRECAUTIONS:
The product you have just unpacked is manufactured with safety in mind and is double checked in the test
department for reliability in its high-voltage section.
The MIC-AMP operates on 115 volt or 230 VAC, 50/60 Hz. In some products there is a voltage-selector built in
on the rear panel that indicates how the unit was set at the factory
If the voltage-selector does not indicate the voltage that your country is using, remove the linecord from the
mains and place the voltage-selector to its proper position. If no voltage selector is mounted inside your
Mic-amp, the factory has already set the mic-amp for the right voltage used in your country.
WARNING
Never change the position of the voltage-selector while the unit is still connected to the mains!
Should any solid object or liquid fall into the cabinet, turn off the unit immediately and have
it checked by qualified personnel before operating it any further.
When the unit is not to be used for a long period, turn the power off to conserve energy and to
extend the useful product life of your unit.
RACK MOUNTING
You can mount the MIC-AMP (height is 1HE, width is 9.1/2") in a 19" rack by using two MIC-AMP modules or
using one MlC-AMP and one blindpanel.
- Allow adequate air circulation to prevent internal heat build-up.
- Do not place the unit on surfaces (rugs, blankets, etc.) or near materials (curtains) that may
block ventilation.
-Do not install the unit near heat sources such as radiators or power-amplifiers or in a places subject to
excessive mechanical vibration.
FUSEHOLDER:
The fuseholder is mounted inside the unit (read product safety. When a fuse is blown, replacing it with a new
one may not be sufficient. The actual cause must be detected and solved.
Contact your nearest dealer if the unit can not be repaired by replacing the fuse. Use only the fuses
specified.
manual page 3