Ambient NanoLockit Quick Start Manual
Browse online or download pdf Quick Start Manual for Camera Accessories Ambient NanoLockit. Ambient NanoLockit 2 pages. Timecode + logging
Also for Ambient NanoLockit: Quick Start Manual (2 pages), Quick Start Up Manual (20 pages), Quick Start Manual (5 pages), Manual (4 pages), Tutorial (5 pages), Quick Manual (2 pages), Manual (19 pages)
Print Page
Lockit
Nano
QUICK START GUIDE
Status LED
Timecode Connector
Micro USB:
Charge and External
Green Button
Power
Red Button
Charge
Power Button
15 min
30 min
~ 2 hrs (full)
Status LED Codes
Mode
flash
ext. power, idle, charging
blink
ext. power, idle, fully charged
int. power, lo bat
Generator Mode:
idle, no TC out, RTC lost
idle, no TC out, RTC OK
generator set, TC out
generator set, TC out, lo bat*
generator set, TC level reduced
TRX Mode:
idle, no TC on input or ACN
TX (LTC/MTC via cable)
RX (LTC/MTC over ACN)
*ca. 30 min left
Example Setup
TC 01:23:45:12
TC IN
NANOLOCKIT
TC OUT
Audio Recorder
TC 01:23:45:12
NANOLOCKIT
DSLR Camera
TC 01:23:45:12
NANOLOCKIT
Film Camera
NOTE: Required cable depends on connected device. E.g. TC-IO for ARRI, LTC-Out/Epic for RED,
LTC-Out for CBMC, Canon, Panasonic, Sony. Please check our website.
1
Turn On all NanoLockits
ACN Antenna
Press the power button on all
NanoLockits for 3 seconds until the LED
lights up green
LEDs start to flash.
Holding the power button on start for 10
seconds until the LED lights up red
will load these factory defaults:
Operation
TC level full, 25 FPS, ACN channel 18
~ 5 hrs
~ 10 hrs
NOTE: On start a valid RTC will be indicated by LEDs flashing
~ 35 hrs
red/green
, a lost RTC by flashing red
1 sec
2 sec
The NanoLockit will always start up with last active
frame rate and output muted.
To activate the output and to jam other
Lockits with the internal Real Time Clock (RTC),
proceed with step 3.
To adjust RTC and frame rate, proceed with step 2A.
To sync TC and FPS from an external device, pro-
ceed with step 2B.
goal: sync timecode (TC) and frame rate (FPS).
Timecode Cable
TC-IO-35RA
Timecode Cable
. Then release and
3 sec
.
TC
FPS
12:45:12:02
25 fps
2A
Set the Internal Clock (RTC)
Use the LockitToolbox to
adjust RTC, frame rate,
and various settings.
(available for PC and Mac
at nanolockit.com).
2B
Set TC from External Source
To sync your NanoLockit
from an external device
connect it to its timecode
output with the appropriate
cable. When the LED starts
flashing green
you can
disconnect the cable.
External jamming sets the TC and FPS
while activating the LEMO output.
3
Set and Jam from RTC or TC
Press the green button
for 3 seconds until LED
double blinks green:
.
This sets the TC and FPS,
wirelessly syncs all other
NanoLockits, and activates
their outputs. Units will flash
green
in sync after jam.
LockitToolbox
RTC
micro USB
TC 01:23:45:12
25 fps
TC
FPS
TC IN
NANOLOCKIT
TC OUT
TC & FPS
3 sec