Ambient Technologies WWTD Installation And Operating Instructions Manual - Page 4

Browse online or download pdf Installation And Operating Instructions Manual for Remote Control Ambient Technologies WWTD. Ambient Technologies WWTD 10 pages. Wireless wall thermostatic on/off remote control

Print Page

Wireless Wall Transmitter:

Installing Wireless Transmitter to Wall:

The wireless transmitter can be installed within a radius of 30 feet with no object in

between the line of sight of the receiver . Choose a mounting location about 5 feet

above the floor in an area with good air circulation and away from the following:

1. Air Ducts

2. Radiant heat from the sun and appliances

3. Concealed pipes and chimneys

Installations:

1. Remove the front housing of the wireless thermostat by pressing the two (2)

tabs on the top of the back housing. Let the front housing swing down 180

degress.

2. Mark the holes positions.

3. Drill two (2) holes and insert the plastic anchors carefully until they are flush

with the wall.

4. Fasten securely the back housing to the wall with the two (2) screws.

Installing Batteries:

The wireless transmitter uses two (2) "AA"- size batteries. To install batteries,

1. Remove the front housing of the wireless thermostat by pressing the two (2)

tabs on the top of the back housing. Let the front housing swing down 180

degress.

2. Insert the two (2) batteries into the cavity as indicated on the back of the front

housing. Make sure the polarity of the battery are correct.

3. Close the front housing until the tab snap into the back housing

4. The batteries should be replaced at least once every 6 months or when the low battery come out on the

LCD display.

Setting Privacy (DIP) Switch on Receiver and Transmitter:

The remote receiver and transmitter privacy (DIP) switches are preset at the factory. Do not set all DIP switches to

"OFF" position or "ON" position. The receiver and transmitter privacy (DIP) swithes are preset at the factory. In

the event of activation or interference from other nearby transmissions, reset the code using the following procedure:

1. Slide the code switches on the transmitter or receiver to your choice of ON or OFF position. Switches #1

to #6 are preset to "ON", and #7 are preset to "OFF" for both the transmitter and receiver.

2. The switches on the transmitter and receiver must match in order for the system to work.

3. The system is now ready to operate.

Receiver

50D0077 Rev 1

Wireless Transmitter

Page 4 of 10

Ambient Technologies

A Division Of MHS