Asko WMC84V Operating Instructions Manual - Page 9

Browse online or download pdf Operating Instructions Manual for Washer Asko WMC84V. Asko WMC84V 16 pages.

Print Page

TROUBLESHOOTING

THE WASHER DOOR WILL NOT OPEN

• Check that the main power switch is on.

• Has the power supply been cut oﬀ ? Check the house

fuses (circuit breakers).

OPENING THE DOOR IN AN

EMERGENCY:

WARNING

The door may only be opened manually if the electric

power is cut and the machine has been drained of

water.

1 First empty the water from the washing machine.

Press and hold the Stop button for three seconds to

pump out the water.

2 Ensure that the main power switch is turned oﬀ and

that the plug has been removed from the wall socket.

3 Take the emergency door opening tool and place it

in the gap on the right side of the washing machine's

door lock. The tool is attached to the rear of the

detergent compartment. Remove the detergent

compartment from the machine and remove the

emergency door opening tool.

4 Push the tool downwards to open the washing

machine door.

THE MACHINE WILL NOT START

• Is the washing machine door properly closed? Push it

ﬁ rmly. Then press the Start button.

• Is there power? Check the fuses and residual current

devices (circuit breakers) in the building.

AFTER POWER FAILURE

Press the main power switch to resume the current

program.

WET WASHING STILL IN THE MACHINE

A small load can occasionally cause an imbalance

Unbalance (see "Unbalance"). Rearrange the load and

start the spin programme, or load more washing and

restart the washing programme.

ERROR MESSAGES

If an error occurs during the program a message is shown

on the display. To exit the message after taking measures,

turn the machine oﬀ and then back on.

The error messages that may be shown in the display are:

Close the Door

Close the washing machine door and press Start to start

the programme.

Over ﬂ ow fault

1 Shut oﬀ the water tap.

2 See "Drainage error".

Water outlet fault

Press the Stop button to empty the machine of water

before opening the washing machine door. If this does not

resolve the problem, call the service division.

Water inlet fault

Check:

• that the tap on the water pipe is open.

• that the ﬁ lter in the machine's water inlet is not blocked.

Action:

1 Shut oﬀ the water tap and unscrew the hose.

2 Clean the ﬁ lter in the inlet valve on the machine.

3 Screw the hose back on and turn on the tap.

4 Run the program again to check if the fault is ﬁ xed.

5 If this does not resolve the problem, call the service

division.

Wash motor fault

Call the service division!

Unbalance

The machine stops the spin cycle if there is too much

imbalance. The washing machine restarts the spin cycle

and hopefully the washing is better distributed in the

drum. This procedure can be repeated up to 10 times.

If the machine still fails to ﬁ nd a good balance, the

programme jumps to the next step.

The error message requires no action.