Ambient Technologies TSMT Operating Instructions Manual - Page 6

Browse online or download pdf Operating Instructions Manual for Timer Ambient Technologies TSMT. Ambient Technologies TSMT 9 pages. Touch screen manual timer

Print Page

Do not use two (2) or more remote control systems in the same area with the same

privacy code setting, as they will communicate with each other. This may cause the

appliances to malfunction.

Resetting the transmitter:

If the transmitter is not working properly, reinstall the batteries to reset the transmitter.

1. Pull out at least one of the batteries.

2. Press any key on the screen to discharge.

3. Wait for 10 seconds and then reinstall the batteries.

Pushing and holding any key for more than 10 seconds until the display refreshes will also reset the transmitter.

n Functions and Operations

General:

The TSMT Remote Control has two (2) operating modes: Manual and Timer.

The transmitter will operate the remote receiver from 1 foot to a maximum of 30 feet. The distance is reduced when

f i r e - p a r t s . c o m

batteries are low.

Manual Mode

In this mode, the TIMER button will only display "TIMER", without showing the time. Pressing the

ON/up and OFF/down buttons will turn on and turn off the fireplace if the TIMER buttons isn't pressed

and flashing.

1. Press the ON/up button to turn on the fireplace. The flame icon on the LCD displays High.

2. Press the OFF/down button to turn off the fireplace. The flame icon disappears.

3. Sliding up and down on the arrow buttons can also turn on or turn off the fireplace.

Timer Mode

Press the TIMER button to enter timer mode. The fireplace will stay on for a period of time as specified

by the timer and then be shut off by the transmitter when the timer counts down to zero.

1. When the TIMER button is pressed, the Set Time appears in the frame of the button and flashes.

2. Use ON and OFF arrows to increase or decrease the Set Time in 15 min increment, between 0:00 to

6:00. Slide up and down on the arrow buttons will increase or decrease the Set Time in 1 hour incre-

ment.

3. Push the TIMER button again to confirm the Set Time, the transmitter sends an ON signal to turn on

the fireplace.

4. The flashing stops and the ON/up and OFF/down buttons become flame controller again.

5. To exit Timer Mode,

a. Push and hold the TIMER button for 3 seconds Or

b. Press the OFF button Or

c. Use the OFF/down buttons to decrease the Set Time to zero.

Page:

Touch Screen Transmitter Manual Timer Instructions

FP2610

Manual mode

FP2611

20300538

timer mode