Asko H5 Use And Care Manual - Page 9
Browse online or download pdf Use And Care Manual for Hob Asko H5. Asko H5 12 pages. Asko h5 hob: user guide
Print Page
building-in
12
preliminary notes
please note:
for Australia:
gas connection RC 3/8"
}
(ISO 7/1-RC 3/8)
A reduction nipple 3/8" to 1/2" (ISO
228-1-G 1/2A) is supplied for those
countries where it is required.
please note:
electrical connection
}
The fitting of the appliance should only be
carried out by registered Corgi gas fitter.
The type of gas in the country for which the
appliance is equipped is stated on the
rating plate.
This appliance must be installed by an
authorised person and the installation and
clearances must be carried out in
accordance with the AS5601 / AG601 Gas
Installation Code.
The appliance is not suitable for connection
with a flexible hose.
The gas connection must comply with
national and local regulations. These
regulations stipulate that:
- only approved materials may be used;
- a flexible tube may not be used behind a
built-in oven or under the hob.
The bottom of the hob becomes hot.
Before operating the appliance, check the
gas connections with a soap/water mix for
any leaks.
H5
240 V a.c., 50 Hz - 0.6 Watt
The electrical connection must comply with
national and local regulations.
building-in dimensions
space required around
}
min. 600 mm
min. 650 mm
min. 450 mm
min. 100 mm
Where cupboards, drawers etc. are
located beneath the hob, there must
be a physical barrier installed at a
minimum clearance of 10 mm from
the base of the hob.
In view of the fact that gas hobs
generate quite an amount of heat it is
necessary, for safe installation, to
allow a sufficient distance between
the hob and non heat-resistant
material (see illustration).
min. 100 mm
min. 10 mm
13