Ambient Weather WeatherHub4 Quick Start Manual - Page 2

Browse online or download pdf Quick Start Manual for Weather Station Ambient Weather WeatherHub4. Ambient Weather WeatherHub4 12 pages. Ambient weather weatherhub4 quick start guide

Print Page
The following table summarizes the USB version for most
weather stations:
Weather Station
Ambient Weather (WS-1080, WS-
1090, WS-2080)
Hideki (Honeywell, Meade)
Oregon Scientific
Davis Instruments USB
Rainwise USB
USB to Serial converters
Use USB Hub for 1.X. No USB hub required for 2.0.
2. Connect the WeatherHub4 to your router or switch.
Note: a cabled connection is required to configure the
device. It can later be disconnected after the optional WiFi
LAN is configured.
3. Connect the AC power adaptor to the WeatherHub4. The
unit will turn on and the status light on the front of the
WeatherHub4 will turn blue. Once the boot up sequence
is complete, the status light will flash purple, then solid
purple (approximately three minutes after power up).
NOTE: if you are connecting to a Wifi Network and
purchased the optional Wireless N Nano, USB Adapter,
connection and configuration of this device is outlined in
Section
1 1
,
C onfiguring as a WIFI Device
X
X
X
USB
1.X
1.X
1.X
2.0
2.0
Check your device
.
X
4
The WeatherHub4 is programmed from the factory for dynamic
addressing (or DHCP). This allows to you to address the unit from
any computer on your network without modifying the IP address.
Page 2
Ambient Weather
6845 W. Frye Road
Chandler, AZ 85226
TEL 480-283-1644  FAX 480-346-3381
www.AmbientWeather.com
Figure 1: Connections
Figure 2: Optional USB Hub/Converter for 1.x Devices

I P Addressing

3 B