Ambient Weather WS-1285 User Manual - Page 5

Browse online or download pdf User Manual for Weather Station Ambient Weather WS-1285. Ambient Weather WS-1285 16 pages. Advanced weather station

Print Page

2.5 Sensor Operation Verification

Verify the indoor and outdoor humidity match closely with the console and sensor array in the same

location (about 10' apart). The sensors should be within 10% (the accuracy is ± 5%). Allow about 30

minutes for both sensors to stabilize.

Verify the indoor and outdoor temperature match closely with the console and sensor array in the same

location (about 10' apart). The sensors should be within 4°F (the accuracy is ± 2°F). Allow about 30

minutes for both sensors to stabilize.

It is recommended you mount the remote sensor on a north facing wall, in a shaded area (the sensor

can mount to a horizontal or vertical surface). Direct sunlight and radiant heat sources will result in

inaccurate temperature readings. Although the sensor is water resistant, it is best to mount in a well

protected area, such as an eve.

Use 3 screws to affix the mounting bracket to the wall, as shown in Figure 1. Connect the remote

sensor to the wall bracket (it will snap into place).

Note: After 30 seconds of inactivity, the display will automatically revert to the normal display

mode (automatic time out).

Note: The MIN/MAX/- functions use the same button and are used interchangeably. The CH/+

functions use the same button and are used interchangeably.

Note: There are two modes of operation (1) normal mode, and (2) set mode, where settings are

programmed.

While in Normal Mode, press the SET key to toggle between the time of day and the year.

While in Normal Mode, press and hold the SET key for at least three seconds to enter the Set Mode.

The first setting will begin flashing. You can press the SET key again to skip any step, as defined

below.

Note: In the Set mode, press the

or the

key for 3 seconds to increase/decrease rapidly.

Note: To exit the Set Mode, press the

30 seconds), and the Set Mode will return to Normal Mode.

Language. The English (EN) language setting will begin flashing. Press the + key to

toggle between the following languages:

Version 1.0

key or the

key to change or scroll the value. Hold the

SNOOZE/LIGHT

button on the top of the display (or wait

key

Page 5