AMC MOUSE 01 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} AMC MOUSE 01. AMC MOUSE 01 7 pagina's. Dual element digital motion detector (dual pyro element + microwave + anti-masking)
Ook voor AMC MOUSE 01: Installatie (4 pagina's)

Pagina afdrukken

DIP 2

Alarm memory function

DIP 3

DUO-MASK function

3. The „tamper disable" jumper

If the tamper indicating enclosure opening will be used in addition to the tamper indicating detachment from

the wall, remove the JP jumper.

Turning off the microwaves – an example of use of the function.

The use of dual element detectors, especially when using the PIR and MW detectors in the

„AND" mode (alarm by both detectors in case of intruder detection), allows to reduce to a minimum the

amount of false alarms.

However, long-term exposure to microwave radiation is harmful to health, and therefore the MOUSE 01

has a feature to block the microwave detector when the Intrusion Detection System is disarmed.

The diagram of connecting the sensor to the control panel with a brief description of the implementation

of this feature is shown below.

The diagram of connecting the MOUSE 01 detector to the control panel to use the locking function of

The OUT3 output of the control panel is programmed as the power supply output (+12V), while the OUT5

output is programmed as the standby indicator.

The "B / S" control input, which is shorted to ground, is used to control the detector.

The alarm memory function activation. This feature enables

quick

This is indicated by slow flashing LEDs. The LED color indicates

which

Red LED - – the alarm is generated by both PIR and WM

detectors. Green LED – alarm by microwave detector (OR

configuration. only).

Orange LED – alarm by PIR detector (OR configuration. only).

This function is implemented by the B/S terminal.

The configuration is the same as for the MW detector.

The alarm memory is reset each time the control panel is armed.

OFF

Turning off the alarm memory.

Switching on the DUO-MASK function. This is a special feature

allowing to determine when infrared or microwave is masked.

The alarm is generated after four-detections of the MW or PIR

detector within 40 seconds after the first activation. After this

time, the detector is zeroed.

OFF

The detector operates in the AND mode. The alarm is generated

by both PIR and WM detectors in case of intruder detection.

microwave detector and the alarm memory function.

determining

which

detector

triggered

the

alarm.