AMCI SD17040C Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AMCI SD17040C. AMCI SD17040C 16 pagina's. Stepper driver

Pagina afdrukken
AMCI SD17040C Gebruikershandleiding

MOUNTING THE SD17040C

Outline Drawing
There are two ways to mount the SD17040C.
!
The first method is with four #10-32 screws into its side panel.
!
The second method is by the mounting tabs. Mounting tabs are for #6 screws.
There are airflow holes in the top and bottom of the enclosure. To ensure adequate convec-
tional airflow, the driver must be mounted in the orientation shown in the drawing.
0.152"
0.312"
0.152"
(3.86)
Grounding
The SD17040C must be grounded for proper operation. The
nected to the SD17040C enclosure and is a sufficient grounding point for most applications. When mounting
the SD17040C on a surface that is electrically conductive and grounded, you should also take steps to ensure
that the two are electrically bonded together. If necessary, remove paint for the bolt mounting surfaces of the
panel to ensure adequate electrical bonding.
Airflow and Wiring Space
To ensure adequate airflow and wiring space, you need two inches (50 mm) of space above and below the
driver, one and one-half inches (37 mm) of space to the left and right of the driver, and one inch (25 mm) of
space in front of the driver. These dimensions are typical for convectional cooling. If you have an active
cooling system such as enclosure fans, you will be able to mount the drivers closer together.
20 Gear Drive, Plymouth Ind. Park, Terryville, CT 06786
Tel: (860) 585-1254 Fax: (860) 584-1973 http://www.amci.com
Minimum and maximum screw lengths should be observed to prevent a screw from
shorting to the PC Board.
2.05"
(52.1)
dia.
(3.86)
1.10"
dia.
(7.92)
(27.9)
0.118"
DIR/CCW
+
(4.78)
DIR/CCW
STEP/CW
+
STEP/CW
DISABLE
+
DISABLE
FAULT
+
FAULT
STEP/FAULT
INTERLOCK
B CTAP
6.71"
B
(170.4)
B
EARTH GND
A
A
A CTAP
INTERLOCK
POWER
GND
AC POWER
N
95 – 132 V
AC
50/60 Hz
L
0.60"
(15.2)
1.000"
typ.
(25.40)
Min. screw length = 0.31"
(7.9)
Max. screw length = 0.62"
(15.8)
7.00"
(177.8)
2.750" (69.85)
0.875"
(22.23)
4.00" (101.6)
connection on the power connector is con-
GND
#10-32 UNF-2B.
Four places.
+ thickness of mounting panel.
+ thickness of mounting panel.
6.15"
(156.2)
4.000"
(101.60)
1.073"
(27.25)
5