FLO-DYNAMICS CMS-120 Snel aan de slag Instructies - Pagina 6
Blader online of download pdf Snel aan de slag Instructies voor {categorie_naam} FLO-DYNAMICS CMS-120. FLO-DYNAMICS CMS-120 8 pagina's. Coolant management system
Pagina afdrukken40201194
CMS-120
QUICK START
Coolant Management System
INSTRUCTIONS
DRAINING THE TANK
Close the ball valve on the black service hose and connect
the open-end adapter.
Turn Tank Control and Assist Control to GREEN.
Move the Flow Control to "ON"
Place the open-end adapter into an approved coolant waste
container and open the ball valve. Drain until the tank is
empty.
Move the Flow Control to "OFF" and Tank Control and
Assist Control to VENT to release pressure in the tank.
Dispose of used coolant in accordance with local and state
requirements.
EMPTY OVERFLOW BOTTLE
Release the Velcro strap and remove the overflow bottle.
Empty contents into an approved coolant waste container.
Rinse out and replace using Velcro strap.
VACUUM GENERATOR OVERFLOW FILTER REPLACEMENT
The vacuum generator overflow filter should be emptied
when it is more than 1/3 full.
Remove the reservoir by turning it counterclockwise. Empty
the reservoir contents into an approved coolant waste
container, rinse out the reservoir, and replace the filter if
necessary.
After ensuring the rubber O-ring is in place, reinstall the
reservoir by turning clockwise until seated.
Flo-Dynamics, Inc. • 3300 Reedy Drive • Elkhart, IN 46514 • 800-303-5874
Page 6 of 8