Amcor 000E Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Amcor 000E. Amcor 000E 8 pagina's. Amcor portable air conditioner owner's manual model ald-12,000e/eh

Pagina afdrukken

Installation

Window Kit Installation

In order for this unit to function

2. Attach Slide Bar Connector,

properly, it must be vented to the

(Round Connector) to the

outside.

other end of the Hose by

extending hose at least 6".

Fitting the Exhaust Hose through

Then tighten Hose by turning

the window is easy. Please see

the (Round Connector)

below.

clockwise.

1. Extend Hose at least 6" and

insert it into back of the unit,

tightening into place by turning

it clockwise.

Wall Connection

1. Make a hole (5.1" in diameter)

3. Extend one end of the Exhaust

in the wall.

Pipe (part #11) and screw into

the Round Connector by

2. Insert the Round Connector

turning clockwise.

(part #13) into the hole and

hold in place by using 4 small

4. Extend other end of exhaust

screws (not supplied).

pipe and screw in Adaptor (part

#10) by turning clockwise.

Slide Bar

Connector

3. Place Adjustable Slide Bar in

the window and expand so it

fits tightly.

4. Lower the window.

5. Make sure the Hose has

no kinks.

Slide Bar has 3 sections which

allows installation in windows up

to 48" in width.

Round

Connector

5. Push Adaptor to fit firmly

over the opening on the back

of the unit.

** When not in use, cover the

Round Connector and hole

with Cap (part #14).

Installation

Mounting the Exhaust Pipe

• The supplied Exhaust Hose can be

extended from 1 foot to 5 feet

for mounting. It is recommended that

you use the shortest possible length of Hose.

• Take care to prevent any kink or

bend in the middle of the Exhaust

Hose, as this will trap hot exhaust air,

which will radiate back into the room.

WARNING!

The length of the Exhaust Pipe is specially

designed according to the specification of

this product.

Do not replace or extend it with your own hose

as this could cause the unit to malfunction.

Cleaning the Filter

Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt from the filters

and then rinse them thoroughly under running water (no hotter than 104ºF)

Dry thoroughly before replacing.

Notice! Never operate the unit without the filters.