Amcor PVMB 15KEH-410 Gebruiksaanwijzing - Pagina 13

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Amcor PVMB 15KEH-410. Amcor PVMB 15KEH-410 16 pagina's. Plmb mono blocs
Ook voor Amcor PVMB 15KEH-410: Engelse gebruiksaanwijzing (13 pagina's)

Pagina afdrukken

STORAGE

• Empty the internal water container.

• Clean the screen filter.

• Remove the active carbon filter before end of season

storage and install new filters at the beginning of the new

season.

• The old filters can be disposed of in the 'Non-biological

rubbish container'.

Replacement filter packages are available from Amcor.

• Put the unit in Fan Only mode for a few hours to ensure

that the inside becomes completely dry.

• Store the cable as shown.

Protect the unit against dust and store in a dry place, not accessible to children.

TROUBLE SHOOTING

Never try to repair or dismantle the air condition yourself. Incompetent repairs result in loss of warranty

and can endanger the user and the property.

Problem

The air

No power supply.

conditioner does

Is the LCD light ﬂ ashing.

not function.

Timer function is active.

The air

In direct sunlight.

conditioner does

Windows or doors open, many

not seem to

people or a heat source in the room.

perform.

Dirty filter.

Air inlet or air outlet blocked.

Room temperature lower than the

selected value.

The unit is noisy. Unit stands uneven.

The compressor

The overheat protection is probably

does not work.

activated.

The remote

Distance too great.

control does not

Remote control signal not detected

function.

by the control panel.

The batteries are drained.

To correct problems that have not been described in the table and/or if the recommended solutions fail

to solve the problem, contact an authorized service centre.

Cause

Connect to a functioning outlet and switch on.

Empty the internal water container.

Deactivate TIMER function.

Close curtains.

Close doors and windows, place an extra air

conditioner.

Clean or replace the ﬁ lter(s).

Remove the blockage.

Change temperature selection.

Place on an even, solid surface (less

vibrations).

Wait 3 minutes until the temperature has

decreased, then turn on the unit again.

Make sure the remote control is correctly

aimed at the control panel.

Replace the batteries.

Solution