Amcor D-1000 Handmatig - Pagina 4

Blader online of download pdf Handmatig voor {categorie_naam} Amcor D-1000. Amcor D-1000 10 pagina's.

Pagina afdrukken

The Amcor D-1000 is a large capacity unit designed to

run highly efficiently in a domestic, commercial or

industrial environment.

The D-1000 keeps air dry and comfortable, prevents

condensation, and creates a better climate to prevent

damages caused by exessive humidity, such as: rusting of

equipment, dry rot of walls, mould growth in store

romms, etc.

It is ideal for places such as: restaurants, bars, printing

presses, indoor swimming pools, jacuzzis, garages,

animal enclosures, cellars, stores, boat sheds, weekend

cottages, archives, etc.

It can be positioned against the wall on legs.

INSTALL AND OPERATE YOUR AMCOR D-1000

1. Correct positioning

It is possible to place the unit against the wall. The

base of the unit at the air inlet must be clear of any

obstruction by at least 400 mm. The top of the unit must

be clear of any obstruction by at least 400 mm.

2. Electrical connections

The Amcor D-1000 must be connected to the power

supply with appropriate leads.

The cord should pass through the hole with the rubber

grommet on the top left side of the unit. Properly fused

disconnect switches must be installed between the unit

and the power source.

3. Condensate drainline

The end of the condensate drain pipe protrudes from

the base of the dehumidifier on the back extending the

pipe long enough to reach the nearest drain outlet and

insert its end.

Check that the condensate water tube does not at any

point slope upwards, which would cause a blockage.

A "U" trap, located in a place where the water will not

freeze, will prevent unpleasant odours from being drawn

into the conditioned space. Where it is necessary for

condensate pipework or an electrical cable to pass

through a wall, a lined or sleeved hole should be made.

Ensure that pipework and cables do not touch each other.

The hole should be sealed when installation is completed.

AMCOR MODEL D-1000

4. Humidity control

automatic humidistat, that switches the dehumidifier On

and Off, to maintain the desired humidity level.

The humidistat should be 24V wall mounted type.

It should be well ventilated and positioned at a height of

about 1.50 m above the floor. The two leads of the

humidistat should be connected to the appropriately

marked terminals on the terminal strip in the electrical

control panel. Those two leads should then be fed to the

vertical, white plastic conduit attached to the internal

dividing panel. Set the humidistat to the level of relative

humidity required in the controlled space. For example,

for normal comfort conditions the setting should be about

50% R.H.

5. Filter

removed for cleaning or replacement. Slide the framed

filter forwards and lift it out. Hold it under streaming

water and flush it clean. Let the trapped water drip off the

filter fabric and replace the

6. De-icer control

de-icer control that guards against ice forming on

refrigeration coils, in low temperature operation, by

shutting off the compressor.

Note: The fan will keep running until all the ice has

defrosted and then, the unit will start up again.

Model D-1000

The unit is controlled by a manually adjustable,

The filter should be regularly checked and if necessary,

Your Amcor D-1000 is equipped with an automatic

dried filter in reverse order.