Floe VSD6500 Assemnly Instructies - Pagina 9
Blader online of download pdf Assemnly Instructies voor {categorie_naam} Floe VSD6500. Floe VSD6500 12 pagina's. Full length pontoon & tri-toon bunks large lifts
Ook voor Floe VSD6500: Montagehandleiding (8 pagina's), Montagehandleiding (16 pagina's)
Pagina afdrukken
Step 5
Place the left & right cradle beams on top of
the frame beams with the top cable holes to
the rear. Special attention should be taken
to insure that the cable ends are in the right
location and a 1/4" spacing is maintained
between the UHMW wear strip and the
corner post. See Fig. 5A.
Now place the front cradle beam so the end
of the beam at the lifting post has the cable
on the top of the sheave. See front cable
orientation to the right.
At this time attach the lifting cable clevis to
the cradle lift clamp using a 3/4-16 x 2" bolt
(fine thread). Make sure the bolt is seated in
the slot of the clamp when tightening the
cable clevis. Do not tighten the clevis
completely at this point. Install a 1/2" x 2"
bolt thru the other hole in lifting clamp with a
nylock nut in the slot on the inside of the
clamp. See Fig. 5B.
Install (7) 1/2" x 2" bolts thru the hole in the
(7) cradle clamps with a nylock nut in the slot
on the inside of the clamp.
Slide (1) cradle clamp over each end of the front
and rear cradle beams. Place (1) cradle U-clamp
over end of each cradle so the bolt holes are
aligned in the U-clamp and the side cradle beam.
Attach the the U-clamps to the side cradles using
(8) 3/8 x 1-1/4" bolts and (8) nylock nuts. Torque
to 35 ft/lbs. Attach the rear cradle beam by sliding
the cradle clamps over the cradle U-clamps. Slide
a cradle clamp over each end of the rear cradle
beam and U-clamp. See Fig. 5C and 5D.
Be certain the clamp the cradle clamps snug
against the cradle u-clamp before tightening the
1/2" x 2" bolts. Also at this time confirm the 1/4"
gap between the side cradle and corner post as
shown in Fig. 5A. Torque bolts to 80 ft/lbs.
Cradle U-Clamp
with bolt holes
towards the inside
of the lift (both ends
and both sides)
Fig. 5C
Approx. 1/4"
Corner Post
Cradle Lift
Clamp
Cradle Guide
Side Cradle Beam
Fig. 5A
SHEET 9 OF 12
Lifting
Cable
Clevis
Fig. 5B
Front Cradle
Cable Orientation
Cradle
U-Clamp
Cradle Clamp
Fig. 5C
Cradle Clamp
Cradle
Lift Clamp
Fig. 5D
Fig. 5D