ACR STOVES BUX2MF Technisch handboek - Pagina 5

Blader online of download pdf Technisch handboek voor {categorie_naam} ACR STOVES BUX2MF. ACR STOVES BUX2MF 17 pagina's. Multifuel stove

Pagina afdrukken

Location of the unit

Clearances to non-

combustible materials

There is a recommended minimum

clearance of 150mm at each side of the

appliance. A clearance of 150mm is

required at the back of stove (if the rear

wall has a thickness of 200mm or more

this measurement can be reduced to

50mm) a recommended clearance of

300mm is required above the appliance

for servicing purposes.

Clearances to combustible

materials

If using an insulated flue with an

integrated appliance connector, such as

the Midtherm HT-S Starter length, the

minimum distance to combustibles is

350mm at the rear and 450mm to the

sides of the appliance. If using a single

walled flue pipe there must be a

minimum clearance of 450mm

clearance at the rear and a 550mm

clearance to the sides of the appliance.

There must be a minimum clearance of

375mm above the appliance to any

combustible materials e.g. wooden

beam.

Curtains and soft furnishings should be

a minimum of 1m away from the

appliance.

Adequate space should be provided for

servicing the appliance.

We do not recommend that televisions

or artwork are positioned above the

appliance.

Please remember that this appliance

has been designed to provide heat and

if installed into a recess enough space

should be left around the appliance to

enable the heat produced to rise and

escape from the recess back into the

room.

Installation Instructions

Hearth Requirements

The appliance must stand on a level

fireproof hearth with a minimum

thickness of 12mm. The hearth

temperature created by this stove is

below 100˚C. The hearth must protrude

at least 225mm in front of the appliance

and 150mm either side of the appliance.

The appliance shall be installed on a

floor with an adequate load bearing

capacity. If an existing construction

doesn't meet with prerequisite, suitable

measures (e.g. load distributing plate)

shall be taken to achieve it.

Flue Requirements

The chimney must comply with current

Building Regulations. Provision must be

made to provide access for cleaning the

appliance, the flue gas connector and

the chimney flue.

The flue must be:

In sound condition and provide

sufficient draft (minimum 12pa)

Suitable for use with solid fuel burning

appliances

Be able to clean the entire length of the

flue system without removal of the

appliance

Free from deposits

Well insulated

At least 4m in height

The flue must not be:

Shared with other appliances

Weight bearing on the appliance

A smaller diameter than the appliance

flue collar size (125mm)