AMD SB750 Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} AMD SB750. AMD SB750 20 pagina's. Based m/b for amd socket am3+ series processor
Ook voor AMD SB750: Gebruikershandleiding (20 pagina's)

Pagina afdrukken
AMD SB750 Gebruikershandleiding
WARNING!
Turn off your power when adding or removing expansion cards or
other system components. Failure to do so may cause severe
damage to both your motherboard and expansion cards.

2-1 CPU Installation

This motherboard provides a socket surface mount, Zero Insertion Force (ZIF) CPU
AM2 socket, referred to as the mPGA940 socket that supports AMD AM3/MA2+/AM2
CPU.
The CPU that comes with the motherboard should have a cooling FAN attached to
prevent overheating. If this is not the case, then purchase a correct cooling FAN
before you turn on your system.
Be sure that there is sufficient air circulation across the processor‟s
WARNING!
heat sink and CPU cooling FAN is working correctly, otherwise it
may cause the processor and motherboard overheat and damage,
you may install an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket
and open it by first pulling the level sideways away from the socket then upward to a
90-degree angle. Insert the CPU with the correct orientation as shown below. The
notched corner should point toward the end of the level. Because the CPU has a
corner pin for two of the four corners, the CPU will only fit in the orientation as shown.
When you put the CPU into the ZIF socket, No force required to insert of the CPU, and
then press the level to locate position slightly without any extra force.
Chapter 2
Hardware Installation
C o l d e n A r r o w
5 5
C P U Z I F m P G A B S o c k e t