cnsat Smart Antenna Selector Gebruiksaanwijzing - Pagina 3
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} cnsat Smart Antenna Selector. cnsat Smart Antenna Selector 14 pagina's.
Ook voor cnsat Smart Antenna Selector: Gebruiksaanwijzing (15 pagina's)
Pagina afdrukkenThe Smart Antenna Selector is equipped with a pre-installed graphical user interface, designed to
add lot of fucntions compared to the rack unit front panel.
There are two installed GUI. One is designed for Windows PC and allow the user to make changes
on basic configuration and manage the Smart Antenna Selector functions. The other one is designed
for Apple Ipad and allow the user to manage only the Smart Antenna Selector funtions, no
configuration can be changed from this GUI.
In both GUIs the user can find the same "buttons" of the rack unit front panel, plus some
informations about the antenna status. The values which can be viewed from both GUIs are:
Antennas A.C.U. ethernet link status, with visible IP address.
Antennas tracking status: with visible tracking satellite and status.
Antenna signal level: with visible AGC and S/N Ratio (for HD11, and TV Series) or BER
(for HD7 antennas).
Antenna position: with visible azimuth relative and elevation
Antenna model: selected from user.
In the following chapters there's a guide of how to use both kind of GUIs.
1 The Smart Antenna Selector can take values from antenna control unit only
via TCP/IP link, so the ethernet link status in one of the most important parameters to observe.
2 The values of the tracking status are the same of the antenna web interface or A.C.U. display.
3 The model is a user selection only via Windows PC GUI. By selecting the model the system react automatically to
have the corrent informations shown. (S/N Ratio or BER).
Chapter 1 - Introduction
3
1
2