Co-op ICE FISHING hut Handmatig - Pagina 14

Blader online of download pdf Handmatig voor {categorie_naam} Co-op ICE FISHING hut. Co-op ICE FISHING hut 14 pagina's.

Pagina afdrukken

ICE FISHING HUT ASSEMBLY

STEP 17. ASSEMBLE THE DOOR

2¾"

36¼"

17.1 Position the Door Stiles (31) and Door Rails (32) as shown and connect

with 3" Deck Screws.

17.2 Attach the Door Sheathing (33) to the door frame as indicated with

1½" Deck Screws.

17.3 Install the Tee Hinge in line with the Door Rails.

17.4 lnstall the Door Handle as desired.

In addition to the Terms of Use found at www.fcl.crs/contact-us/privacy-terms, you are responsible for any applicable code approval or permits associated with the construction and use of this plan.

Check with a building-code official or a building expert to make sure that the materials and construction methods shown meet local codes and conditions and are suitable to your situation. It is the

responsibility of the builder to ensure the proper tools, measurements, cuts and building techniques are used in the construction of this plan. CO-OP

of this information. Please ensure the manufacturer's instructions are followed in the use of all tools and materials and heed all recommended safety guidelines.

®CO-OP and design trademark are registered trademarks of Federated Co-operatives Limited, Saskatoon S7K 3M9

(continued)

3" Deck Screws - 6

1½" Deck Screws - 28

4" Tee Hinges - 3

5½" Door Pull - 1

4¾"

2¾"

36¼"

Sheathing

overhangs

the door

frame

by 1/4".

36¼"

2¾"

STEP 18. SET THE DOOR AND WINDOW

NOTE:

• The window panel was not included in the materials

list at the start of these assembly instructions.

• A variety of materials can be used for this optional

component, including clear acrylic or polycarbonate

panels.

• A detail drawing of the window assembly, including

dimensions, is shown below.

Optional

Window Assembly

237⁄8"

16"

1 ½ " Deck Screws - 8

18.1 Secure the hinges to the Trimmer Stud.

18.2 Working from the inside of the shelter, place the Window Panel in the

rough opening.

18.3 Secure the panel by attaching the Window Retainers (34) to the studs

and blocking around the rough opening with 1½" Deck Screws.

18.4 If desired, wall, joist and rafter cavities can now be filled with insulation.

assumes no responsibility for the incorrect use