Amdi PARTNER/STEPPER Instructieblad - Pagina 2

Blader online of download pdf Instructieblad voor {categorie_naam} Amdi PARTNER/STEPPER. Amdi PARTNER/STEPPER 2 pagina's. Augmentative communication devices

Pagina afdrukken
OUTPUT JACK:
The jack labeled OUT on the back of the STEPPER is an Output jack used to control low voltage DC
devices. When the message square is depressed, the jack labeled OUT is shorted and a low voltage device
plugged into that jack will be activated.
PLAYBACK OPERATION: (Repeat switch in the OFF position)
1.
Turn the STEPPER ON. Turn the VOLUME control switch to the left, until it clicks ON.
2.
Set the VOLUME control, turning to the left, until the desired playback volume is reached.
3.
Press the message square on the face of the STEPPER to playback the first message.
4.
Press the message square again to play the next message in the sequence.
5.
After the last message in the sequence has played, the STEPPER will go back to the first message again.
REVERSE FUNCTION:
1.
Press the REVERSE button on the back of the STEPPER and then the message square, the previous message will play.
2.
Each time the REVERSE button (see diagram above) is pressed, the STEPPER will go back another message.
REPEAT FUNCTION:
1.
Press the message square to advance the messages until the desired message to be repeated has played.
2.
Slide the REPEAT switch located on the back of the STEPPER to the ON position (see diagram above).
3.
Now, each time the message square is pressed, the same message will play.
RESET FUNCTION:
1.
Pressing the RESET button located on the back of the STEPPER will reset the messages back to the first message stored in the
sequence (see diagram above).
2.
The RESET switch can be press at any time you need to go back to the first message.
OVERLAY DESIGN AND LAYOUT:
There are several methods you can use to make overlays for the STEPPER.
Draw or print corresponding icons or words on a sheet of 3.75" by 4.75" paper.
1.
Develop your custom overlay using Mayer Johnson's BOARDMAKER™ Software.
2.
CLEANING THE STEPPER
Note: DO NOT SUBMURGE THE STEPPER IN WATER... THE STEPPER IS WATER RESISTANT - NOT WATER PROOF.
1.
Turn the STEPPER off.
2.
Remove the overlay from the switch grid.
3.
With a wet wash cloth and mild soap wipe the soiled areas clean.
4.
To rinse, use a wet sponge (cold water) and wipe away the soapy area. DO NOT SUBMURGE under the water and do not
allow water to enter the external speaker, record jack or speaker holes.
Care and Maintenance
The STEPPER is designed to automatically power down after a message is played. However, the power down mode is still an active mode and
drains some power from the battery, affecting battery life. Therefore, if the STEPPER is not going to be used for a long period (2 to 3 hours) it is
recommended that the unit be turned off.
If the STEPPER fails to operate, or operates incorrectly, follow these steps
1.
Check if the batteries are installed correctly.
2.
Check if the STEPPER is ON and a Message has been recorded. Also make sure there are no obstacles blocking the message
square.
3.
Turn the STEPPER OFF for 15 Seconds, then back ON and retry playback.
4.
Replace the Batteries.
5.
For further assistance, feel free to contact our technical support team at 1-866-ERI-7255
95 Sherwood Avenue
Farmingdale, NY 11735
Phone: (631) 531-8888
Fax: (631) 531-8811
1-888-353-2634
http://www.admi.net