Amdi PARTNER/PLUS STEPPER Version 2 Instructieblad

Blader online of download pdf Instructieblad voor {categorie_naam} Amdi PARTNER/PLUS STEPPER Version 2. Amdi PARTNER/PLUS STEPPER Version 2 4 pagina's. Augmentative communication devices

PARTNER/PLUS STEPPER
INSTRUCTION SHEET
Congratulations on your purchase of the PARTNER/PLUS STEPPER Entry-Level Communicator. T
STEPPER
IS THE FIRST ENTRY
IMPORTANT FEATURES FOR A VERY LOW PRICE
STANDARDS TO PROVIDE MANY YEARS OF RELIABLE OPERATION
6
,
FOR
MONTHS
INCLUDING PARTS AND LABOR
D
F
PARTNER/PLUS STEPPER
ISTINCTIVE
EATURES OF THE
S
EQUENCE MESSAGES OF ANY AMOUNT UP TO
A R
ESET BUTTON IS AVAILABLE TO SET YOU BACK TO THE
D
ROP RESISTANT
W
ATER RESISTANCE FOR EASY CLEANING
T
HE SHATTERPROOF CASE IS MADE OF A HIGH IMPACT PLASTIC
L
IGHT WEIGHT AND PORTABLE
T
PARTNER/PLUS STEPPER
HE
M
ESSAGES CAN BE STORED FOR UP TO
O
BJECTS CAN BE PLACED ON A
E
P
ACH
ARTNER
L
OW PROFILE PANEL ACTUATION FOR PEOPLE WITH LIMITED REACH
L
OW ACTUATION FORCE
I
N ADDITION TO THE BUILT
EXTERNAL DEVICE OR BE ACTIVATED THROUGH AN EXTERNAL SWITCH
GENERAL OPERATION:
All controls are located on the back of the PARTNER/PLUS STEPPER.
The PARTNER/PLUS Stepper augmentative communicator is a self-contained communication device, which permits the user to record and
playback a sequence of messages with up to 60 seconds of total recording time. Graphic overlays (picture cards) can be easily changed by simply
sliding them into the designated area on the actuation panel. Objects can be placed on top using the Velcro strip. Laminated or plastic picture
cards can be placed in the slot provided on top of the Partner/Plus Stepper. Simple to operate, just turn the unit on, adjust the volume and press
the panel to activate the messages.
BATTERY INSTALLATION
1.
Make sure that the PARTNER/PLUS STEPPER is turned off. Set VOLUME control switch fully to the right, until it clicks off.
2.
Turn the PARTNER/PLUS STEPPER over and lay the front of the unit on a flat stable surface.
3.
To gain access to the battery compartment and expose the batteries, remove the screw holding down the plastic battery cover on
the bottom of the unit.
4.
Remove the old batteries and discard them in accordance with your local recycling laws.
5.
Install the new batteries observing the proper polarity and using 3 new AA batteries.
6.
Then replace the battery compartment cover by placing the cover over the access hole and tighten up the screw. Insure the
battery cover is secure.
RECORD OPERATION:
Note: It is important during any recording operation that the built in microphone located at the back of the PARTNER/PLUS STEPPER
is clear and open.
1.
Turn the PARTNER/PLUS STEPPER ON. Turn the VOLUME control switch clockwise, until it clicks ON.
2.
Set the VOLUME control, turning to the left, until it reaches the center of the range.
3.
Depress and hold the built-in record switch. The record switch must be engaged for the entire recording process.
4.
Press and hold down the panel, the Recording LED on the back next to the Recording button will turn on.
5.
As soon as the Recording LED turns ON begin to say your message into the built-in microphone located at the back of the
PARTNER/PLUS STEPPER next to the volume control wheel. For the best results, you should speak directly into the
microphone and be about 6 to 9 inches away from it in a quiet location, any surrounding noise will be in the back ground of the
recording. Release the panel when you are finished speaking the message.
6.
Continue to hold in the RECORDING button and then press and hold down the panel again and start speaking the next message.
When you are finished speaking the message, release the panel.
7.
When all the messages in the sequence are finished recording, release the RECORDING button.
V
ERSION
-
A
LEVEL
UGMENTATIVE COMMUNICATOR TO OFFER HIGH QUALITY
. PARTNER/PLUS STEPPER
. *
60
SECONDS OF TOTAL RECORDING TIME
,
ABLE TO WITHSTAND ROUGH HANDLING
.
(
1
.)
LESS THAN
LB
"R
GIVES YOU
EAL
100
YEARS WITH NO POWER
V
ELCRO STRIP OR A PICTURE CARD CAN BE PPLACED IN A SLOT STANDING UP
/P
STEPPER
LUS
CAN BE CONNECTED TOGETHER TO BUILD A
,
SO PEOPLE WITH LIMITED STRENGTH CAN ACTIVATE THE
-
,
IN MICROPHONE
SPEAKER AND RECORD SWITCH
*S
W
EE
1
A
C
UGMENTATIVE
IS MANUFACTURED TO THE HIGHEST COMMERCIAL
. W
E FULLY GUARANTEE THE
.
F
IRST MESSAGE AT ANY PLACE IN THE SEQUENCE
.
.
-V
"
OICE
HIGH QUALITY AUDIO REPRODUCTION
. C
HANGING THE BATTERIES IS A SNAP
T
WO OR MORE MESSAGE COMMUNICATOR
.
P
ARTNER
, O
OUTPUT
NE
.
ARRANTY AGREEMENT FOR DETAILS
D
OMMUNICATION
EVICES
,
RELIABLE PERFORMANCE AND MANY
PARTNER/PLUS S
.
.
.
.
.
/P
STEPPER.
LUS
O
INPUT
JACK AND
NE
JACK IS PROVIDED TO TURN
.
PARTNER/PLUS
HE
'
TEPPER
S OPERATION
ON
AN