Coalesse E-table 2 Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} Coalesse E-table 2. Coalesse E-table 2 15 pagina's.

BEFORE YOU BEGIN:

Make sure you have all the table components:

Table Top

(1) piece table top OR

multiple piece table top. Tite-Joint ™ Fasteners will be included

multiple piece table. Keep all top sections with matching set ID numbers together

Table Bases

(2) bases for tables 12' or shorter OR

(3) bases for tables from 14', up to 20' long OR

(4) bases for tables over 20' long

Utility Bay

Quantity is order dependent.

Wireway Assembly

(1) power infeed - There are three types.

(1) Wireway assembly for two-base tables, OR

(2) Wireway assemblies for three-base tables OR

(3) Wireway assemblies for four-base tables

Hardware

#10-24 x 3/8" Pan-Head Phillips machine screws, black. Quantity varies with table size and configuration.

(Laminate and Veneer base tables only) #10 Type A X 1-1/4" Pan-Head Phillips wood screws, black. Quantity varies with table size and

configuration.

#12 Type A x 1" Pan Head Phillips wood screws, black. Quantity varies with table size and configuration.

Duplex Outlets

These are ordered separately from the table but will be factory installed. Duplexes are identified with numbers corresponding to their circuits: 1

through 3. Only Circuit 1 duplexes will work with single circuit plug infeed.

Optional

Floor Monument Cover

Flexible cord conduit

Drill driver with #2 and #3 Phillips head bits

Short (less than 6" long) Phillips screwdriver, #2

Rubber Mallet and Nail Set (for Tite Joint Fasteners on two piece tops)

NOTE REGARDING HARDWIRE POWER IN-FEEDS

A LICENSED ELECTRICIAN MUST CONNECT THE POWER IN-FEED (S) TO THE BUILDING POWER SOURCE IN ACCORDANCE WITH ALL NATIONAL AND LOCAL

ELECTRICAL CODES. THESE ELECTRICAL ASSEMBLIES ARE INTENDED FOR INSTALLATION IN ACCESSIBLE DRY LOCATIONS IN ACCORDANCE WITH ARTICLE 604

OF THE NATIONAL ELECTRIC COD NFPA70. IF YOU HAVE ANY CONCERNS ABOUT A SPECIFIC APPLICATION PLEASE CONSULT THE LOCAL AUTHORITY HAVING

JURISDICTION. THIS SYSTEM IS RATED FOR A MAXIMUM OF 20 AMPS, 125/250 V, 1-PHASE, 60Hz OR 120/208 V, 3-PHASE, 60Hz.

WARNING: "RISK OF FIRE OR ELECTRICAL SHOCK. DO NOT ELECTRICALLY CONNECT TO MORE THAN ONE SOURCE OF SUPPLY. ALWAYS DETERMINE THAT THE

WIRING ASSEMBLY IS ELECTRICALLY CONNECTED TO ONE AND ONLY ONE SOURCE OF SUPPLY"

Page 2 of 15

939500448 Rev E