10Bar FL 50 - Hot-shoe clip-on Flash Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} 10Bar FL 50 - Hot-shoe clip-on Flash. 10Bar FL 50 - Hot-shoe clip-on Flash 11 pagina's. Camera housing

Pagina afdrukken

5. Use & Care of Housing:

5.1 Pre Dive Function Check.

Just before entering the water, make a habit of reviewing that you have carried out the

proper steps to close the housing. and the pressure release plug screwed home. Make a

visual check of the O-ring seal. It is also useful to switch on the camera, and check that

controls e.g. on/off, zoom, shutter functions operate normally. In case of misalignm ent of the

camera, simply open the case and correct the problem.

Check housing is closed.

Close pressure release plug

Check battery is full

Check sync cord is connected to the camera housing

Shot the camera at Auto mode

If there is a large change of temperature and the housing is not opened for

maintenance between dives, it is recommended to equalize the possible

pressure difference between the inside of the housing and the ambient by

opening the pressure release plug and close it firmly subsequently.

Always avoid submerging the housing in hot water for a prolonged time or a

cleansing tank where the water may be heated up by the sun.

5.2 General Operation.

The control levers and push buttons consist of internal double O -ring seals on a

stainless steel shaft. This arrangement is very reliable, however as a precaution, when

operating the controls, avoid excessively rapid movements, as this may distort the O-ring.

Also please allow for the fact that the camera takes a few seconds to power on. If the camera

dose not appear to respond to a control action, make sure that no other controls are pressing

on the camera, i.e. locking out further actions. Wear the wrist strap; it is easy to

inadvertently let go of the housing, especially if you are distracted.

5.3 Cleaning & Storage.

The body & lid of the housing are made of polycarbonate. Polycarbonate was selected

for its outstanding strength stiffness, hardness and toughness. As well as its crystal clear

transparency and high gloss surface. It has good resistance to weathering, although long-

term exposure to sunlight should be avoided. Normal operating temperature range is 3°C to

36°C (Storage temperature: -10°C to 50°C)

8/6/2006