aero pure AP120-S Handmatig - Pagina 3
Blader online of download pdf Handmatig voor {categorie_naam} aero pure AP120-S. aero pure AP120-S 5 pagina's. Ventilation fan
Ook voor aero pure AP120-S: Gebruikershandleiding (4 pagina's)
Pagina afdrukken
2
ASSEMBLY INSTRUCTIONS
5. INSTALL DUCTWORK
Connect the round ductwork (not included) to the damper/duct connector,
and run the ductwork to a roof or wall cap (not included). Using duct tape
(not included), secure all the ductwork connections so that they are air tight
Insulated flexible duct is recommended for the quietest possible installation.
If rigid duct is used, a short (1-3 feet) section of insulated flexible duct will
ensure quiet operation.
The ducting from this fan to the outside of building has a strong effect on
the air flow, noise and energy use of the fan. Use the shortest, straightest
duct routing possible for best performance, and avoid installing the fan with
smaller ducts than recommended. Insulation around the ducts can reduce
energy loss and inhibit mold growth. Fans installed with existing ducts may
not achieve their rated air flow.
CONNECT ELECTRICAL WIRING
Run 120V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to
the wiring plate. Refer to the wiring diagram and connect the wires as shown.
FOR AP120-S
FOR AP120H-S
INSTALL GRILLE
Install ceiling material to complete the ceiling construction. Then cut around
the fan housing.
To attach the grille assembly to the fan housing, pinch the grille springs on
the sides of the grille assembly, and position the grille into the housing
with the grille springs in the appropriate slots. Gently push the grille
assembly towards the ceiling to secure.
READ AND SAVE THESE INSTRUCTIONS
Installer: Leave this manual with the homeowner