Canon 9318A001AA Vereenvoudigde onderhoudshandleiding - Pagina 14

Blader online of download pdf Vereenvoudigde onderhoudshandleiding voor {categorie_naam} Canon 9318A001AA. Canon 9318A001AA 22 pagina's.

7. SPECIAL NOTES ON SERVICING IN ASIA

7-1. Resetting the Main and Platen Waste Ink Counters

The iP2000 has separate waste ink counters for the main waste ink absorber and the platen waste

ink absorber, respectively. At waste ink absorber replacement, in the service mode, reset the

applicable waste ink counter according to the replaced waste ink absorber. (When both the main and

platen waste ink absorbers are replaced, reset both the main and platen waste ink counters.)

For the main waste ink absorber, a new design has been adopted so that a half portion of the main

waste ink absorber can be replaced just by removing the printer housing.

When compared with replacement of the entire main waste ink absorber, replacement of the half

portion is extremely simple and easy, as it does not require removal of other components such as

the chassis and ASF.

The printable number of pages after replacement of the half portion of the main waste ink absorber

is 2,000 pages.

According to the above, 2 methods are available for replacement of the main waste ink absorber,

and the main waste ink counter should be reset according to the replacement method.

- Replacement of the half of the main waste ink absorber:

Easy, and the printable number of pages after the replacement is approx. 2,000.

- Replacement of the entire main waste ink absorber:

Difficult, and the printable number of pages after the replacement is approx. 4,000.

After replacement, the main or platen waste ink counter should be reset according to the replaced

absorber portion.

Replaced waste ink absorber

Entire main waste ink absorber

Half of the main waste ink absorber*

Entire platen waste ink absorber

* How to replace half of the main waste ink absorber:

Remove the upper cover unit.

Replace the 4 ink absorbers (2 types, equivalent to half of the main waste ink absorber),

shown in the figure below.

1. Error check

Perform EEPROM information printing, and check the following values:

- D:

Main waste ink counter

- PD:

Platen waste ink counter

2. Replace the applicable waste ink absorber(s).

3. Reset the waste ink counter.

For waste ink counter resetting procedures, see 4. ADJUSTMENT / SETTINGS, 4-2. Service Mode.

Waste ink counter value

Reset the main waste ink counter (0%).

Re-set the main waste ink counter value to 50%.

Reset the platen waste ink counter (0%).

Replaceable half portion (4 ink absorbers)

After the half portion is replaced, re-set the

waste ink counter to 50%.