aero-naut Princess Gebruiksaanwijzing - Pagina 7

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} aero-naut Princess. aero-naut Princess 17 pagina's. 3081/00

Caution !

The next three stages, which are described

on this page, must be carried out while the

glue is still soft. This means that there is

little time for adjustment, so please check

once more that the bottom panels 24 are an

accurate fit before reaching for the glue.

Remove the bottom hull panels 24 and

apply glue to the inside of the central joint.

Continue with the next stages 17 + 18

immediately, i.e. before the glue has a

chance to set.

Sand the wide face of the triangular stringers 26

over a length of about 50 mm from the front end

(keel 12), so that they taper and take up a pointed

shape towards the bow. Starting at the half-way

point and working towards the bow, saw half-way

through the triangular stringers 26 at 10 mm

intervals, as this makes it easier for them to

conform to the curvature of the hull.

Apply glue to frames 1 - 11, the keel 12,

the fore-and-aft bearers 13, the keel

components 14 and the stringers 17 + 19 -

21, then lay the bottom panels 24 on the

hull, aligning them with the side panels 23

at the bow.

Press the bottom panels 24 together at the

bow to remove any gap, and pin the parts

in place. Now pull the bottom panels 24

against the side panels 23 as shown, using

plenty of strips of adhesive tape. Ensure

that the bottom panels overlap frame 1.

Glue the triangular rails 26 to the hull, with

the outside edge flush with the bottom

panels 24, overlapping the side panels 23

towards the stern, and secure them with

strips of adhesive tape.

Kielteile