Aktakom ASE-1107 Gebruiksaanwijzing - Pagina 11

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Aktakom ASE-1107. Aktakom ASE-1107 15 pagina's.

2. Broken Soldering Iron Cord

There are two methods of

testing the soldering iron cord.

3. Replacing the Fuse

1. Turn the unit ON and set the temperature control knob

to 899°F.

Then wiggle and kink the iron cord at various locations

along its length, including in the strain relief area. If the

LED heater lamp flickers, then the cord needs to be

replaced.

CAUTION! The LED heater lamp will flicker even

with a normal Iron cord if the temperature reaches

899°F.

2. Check the resistance between the pin of the plug and

the wire on the terminal.

Pin1: Black Pin2: Yellow Pin3: Green

Pin4: White Pin5: Red pin the value should be 0Ω. If it is

greater than 0Ω or is ∞, the cord should be replaced.

Refer to the drawing on the parts list. Desolder the Blown

fuse and remove it. Solder the new one.