Aktakom ASE-1107 Gebruiksaanwijzing - Pagina 5

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Aktakom ASE-1107. Aktakom ASE-1107 15 pagina's.

Pagina afdrukken
6 5 0
↓
Press "UP" or "DOWN"
6 6 0
Press "*" button once.
↓
6 6 0
↓
Press "*" button once.
6 6 0
To change the setting
temperature when the
card is left in the
station, refer to the
followings.
The card
Stacking Stations
3. Select the desired value of the 10's digit.
Press the "up" or "down" button to change the displayed
value as shown below.
After selecting, press the "*" button.
After that, the l's digit will flash to indicate that the l's
digit can be set.
4. Select the desired value of the 1's digit.
Press the "up" or "down" button to change the displayed
value as shown above.
After selecting, press the "*" button.
Here, pressing the "*" button...
a)
Save the setting temperature.
b)
Displaying the setting temperature.
c)
Starts heater control.
Note: If you turn off the power switch during the
temperature setting, setting value will not be stored
into the memory.
1. Push the * button and hold it down for at least Is. First the
present setting temperature will be displayed, and then the
100's place digit will begin to flash. This flashing indicates
that the temperature-setting mode has been entered.
After begins flashing, proceed with the setting temperature.
2. If the * button is pressed for less than Is, the present setting
temperature will be show for 2s and then the display will
return to showing the tip temperature.
1. After setting temperature, remove the card. The preset
temperature cannot be changed until the card is reinserted,
even, even if the power switch is turned off. This allows
you
a)
To turn the power off and on without having to reset
thetemperature each time.
b)
Accurate and safe temperature control.
2. Any card can be used with any station.
3. Even if the card is left in the station, the soldering station
can be operated normally. If the power is turned off while
the card is inserted, the soldering iron will heat up to the
preciously setting temperature.
For greater convenience and soldering efficiency, two stations
can be securely stacked.
4