Aktobis WDH-FGA1075 Handmatig - Pagina 9

Blader online of download pdf Handmatig voor {categorie_naam} Aktobis WDH-FGA1075. Aktobis WDH-FGA1075 12 pagina's.

Condensation:

Some condensation forms in the unit during the cooling process. This side effect is caused by the extraction of

moisture from the ambient air during the cooling process. This condensation water is collected and fed into the

integrated condensation tank. If the integrated condensation tank is full, the compressor and the motor of the air

conditioner switch off. In addition, this condition is signalled by the "Water Full" signal light on the control panel and

by a beep !

To drain the condensation water tank and thereby reactivate the air conditioner, please follow the steps below:

1. Switch off the air conditioner and avoid moving the unit when the

condensation tank is full.

2. Position a drip tray below the drain hole (1) for the condensation water.

3. Unscrew the cap (3) and then remove the rubber plug (2) by pulling it

out horizontally. Now the condensation water can drain out of the tank.

4. If your drip tray is full but there is still water in the condensation tank,

simply put the rubber plug back on the drain hole and then empty the

drip tray.

5. Repeat this procedure until the condensation tank is completely empty.

6. Now put the rubber plug back on the drain hole and finally screw the

cap back on properly.

7. Finally, you can switch the mobile air conditioner on again and the

"Water Full" signal light on the control panel should now go out.

If you want to operate the air conditioner without the condensation tank,

please take the following steps:

1. Unscrew the cap and then remove the rubber stopper by pulling it out horizontally. Keep both cap parts in a

safe place for later use.

2. Connect the plastic hose supplied to the condensation drain hole and lead off the other end so that there is a

slope and the condensation can drain off easily/unhindered (see fig. below).

3. The drain hose can be extended or also replaced. In this case, please use a suitable hose. A 3/4 inch hose is

best suited/fitting.

Rubber stopper

Sealing cap

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de

Plastic hose