Bobet LS Ecoprem Specificaties - Pagina 2
Blader online of download pdf Specificaties voor {categorie_naam} Bobet LS Ecoprem. Bobet LS Ecoprem 4 pagina's. Sole-washer
Pagina afdrukken- 1 button start/stop
- 4 adjustable feet, polyurethane base and stainless steel stems
- 1 electrical box
- 1 key for the electrical box
- 1 manual of instruction
The installation of this sole-washer Ecoprem requires :
- 1 power supply 400 volts three-phase + earth (4G 2.5 mm²), protected by a differential circuit breaker 30 mA
- 1 power supply in hot water maxi 40°C - internal diameter 19 mm
- 1 80-mm diameter dirty water drain or gully in the floor
DESCRIPTION :
Overall length :
Overall Width :
Overall Height :
Noise Level :
Motor power :
Index protection :
Motors voltage :
Control voltage :
Frequency :
Water Consumption :
Concentration of disinfectant product :
APPLICATION :
ADVICE TO USE
- For the dosing pump (0.2 to 2%), use degreasing, disinfectant, non-foaming and fluid products (like water) with a
neutral pH, or if not, use products with a chlorine content not exceeding 400 PPM guaranteed at 1%. We have tested 2
products which meet these requirements : INDAL TA 400 (Code Bobet 2226 can of 24 kg) or INDAL MTA (Code Bobet
12339 can of 20kg or Code Bobet 15734 can of 5 kg).
- If you change the disinfectant product, thoroughly rinse the dosing device (10 minutes) before introducing the new
product (the mixture of the two products could cause a chemical reaction which would damage the dosing device).
- Do not use hot water at more than 40°C.
- When installing, take care to thoroughly prime the water pipe before connecting it to the dosing device (we strongly
recommend fitting a filter).
- When cleaning after use do not use high pressure cleaning equipment directed on the electric equipment (control box,
solenoid valves, etc).
- To avoid clogging of the Venturi, it is recommended to daily rinse when starting the device, the Venturi firstly
positioned on the flush mode.
- This equipment must be placed in a place free from frost and away from heat sources.
FAM 31.3103 (INOX TECHNO HYGIENE.LAVE SEMELLE) - LAVE_SEMELLES_LSECOPREM
1953 mm
500 mm
1133 mm
Weight :
100 kg
72 dB
0.75 kW
IP 55
400 V three-phase + earth
24 V AC
50 to 60 Hz
4 l/mn at 4 bars
adjustable from 1% to 40%
Page 2/4
v21 du 25/01/2017
fiche N°1518