BOBPERRY AUDIO ATC 2 Handmatig - Pagina 2

Blader online of download pdf Handmatig voor {categorie_naam} BOBPERRY AUDIO ATC 2. BOBPERRY AUDIO ATC 2 8 pagina's. Automatic talkback controller

What does Bob Perry ATC 2 do?

Bob Perry ATC 2 can automatically mute your talkback channel when start recording or

playback in your DAW. So the musician in the recording room can always hear the engineer

when not recording or reviewing a recording. In addition to this, it incorporates a compressor

for the talkback channel, which can be used to enhance intelligibility.

TALKBACK:

A way for the engineer to talk to the musician

LISTENBACK: A way for the musician to talk to the engineer (and for the engineer to "listen"

to the musician)

Setting up Bob Perry ATC 2

1) Make a new track (mono). Call it "Talkback" or something similar.

2) On this track, select the input your talkback microphone is connected to.

3) Load Bob Perry ATC 2 into one of the track's insert/FX slots.

4) Assign the output of this track to the headphones mix of the musician.

5) Fine tune this channel with the VOLUME and COMPRESS knobs.

6) (optional) Enable MIDI TRIGGER and assign a MIDI controller to control the TALK button.

7) (optional) add an ATC 2 plug-in instance to your master bus and enable

MASTER BUS MODE in it.

VST is a software and trademark of Steinberg Media Technologies GmbH.

Definition of Terms

Bob Perry ATC – Manual – Page 2/8

011321160820