Euro-Pro B20301 Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Euro-Pro B20301. Euro-Pro B20301 6 pagina's. Cyclonic bagless upright

Pagina afdrukken

GETTING TO KNOW YOUR CYCLONIC BAGLESS

UPRIGHT

1. Upper Handle

2. On/Off Switch

3. Dust Cup Release Button

4. Dust Cup

5. HEPA Filter Frame

6. Carpet Height Selector

7. Furniture Guard

8. Head Light

9. Motorized Power Head

Technical Specifications

Voltage:

120V., 60Hz.

Power:

12 Amps

Note: Illustrations may differ from actual unit.

10. Flexible Hose

11. Power Cord

12. Quick Release Power Cord Holder

13. Round Brush

14. Upholstery Brush

15. Crevice Tool

16. Extension Tubes (x2)

17. Hose Connector

18. Carpet-to-Floor Selector

OPERATING INSTRUCTIONS

Motor Thermostat

Important:

This unit is equipped with a

motor protective thermostat. If for some

reason the vacuum cleaner should

overheat, the thermostat will automatically

turn the unit off. Should this occur:

•

Push the On/Off button once.

• Disconnect the plug from the

power source.

• Check the source of overheating

problem. (i.e. clogged hose or filter)

• If clogged hose or filter is found,

unclog the hose and replace the

filters.

• Wait at least 45 minutes before

attempting to reuse the vacuum.

• After unit has cooled down for 45

minutes, plug in the cleaner and push

the On/Off button. The vacuum should

start again.

• If the vacuum still does not start,

contact customer service at

1 (800) 798-7398.

Cleaning & Changing the Belt

Warning: To reduce the risk of electric

shock, the power cord must be

disconnected before removing the dust

cup, HEPA filter,changing the filters or

performing maintenance/trouble shooting

checks.

Occasionally the power nozzle drive belt

will require changing, the frequency will

depend upon the amount of use your

vacuum sees.

1. Turn the vacuum "Off" and unplug

from power supply.

2. Turn the vacuum upside down on a

flat level surface.

3. With a coin or a thick flat head

screwdriver, unlock the two (2)

screw locks by turning counter-

clockwise. (Fig. 21)

Fig. 21

4. Remove the bottom cover of the

power head.

5. Lift the right side of the agitator brush

first and then lift the left hand side and

lift the agitator brush out of the power

head.

4. Remove the bottom cover of the power

head.

5. Lift the right side of the agitator brush

first and then lift the left hand side and

lift the agitator brush out of the power

head.

6. Carefully remove any belt residue that

may exist in the belt area.

7. If the belt has broken, remove any

loose pieces before replacing with a

new belt.

8. Remove the worn or broken belt from

the motor drive shaft.

9 Loop the new belt first over the motor

drive shaft and then over the agitator

pulley. (Fig. 22)

Insert

First

Fig. 22

10. Insert the left side of the agitator in

first by placing the end cap down into

the slot and then do the same with the

right side. Press firmly to make sure

that each end is completely inserted.

11. Check to make sure that the belt is

centered on the pulley and that the

agitator turns freely.

12. Replace the top cover over the power

head base and lock in place by turning

the two screw locks clockwise until you

hear them lock in place.