Euro-Pro SHARK V1925 Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Euro-Pro SHARK V1925. Euro-Pro SHARK V1925 8 pagina's. 4.8 volt dc cordless rechargeable sweeper with no touch dust cup
Ook voor Euro-Pro SHARK V1925: Gebruiksaanwijzing (8 pagina's)

Pagina afdrukken

Operating Instructions

Charging Instructions

Connect the charger plug to the charging jack or hole on the backside of the

sweeper. Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only

K-TEC charger KA12D075015023U. (Fig. 2)

Charging

Light

Indicator

This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must

be charged for a minimum 20 hours.

When recharging the unit, the unit must be turned off.

The charging light indicator on the top of the sweeper will illuminate to indicate

that the sweeper is properly charging.

To recharge, repeat step #1 above. Charging times will vary depending upon the

amount of usage between charging cycles.

Note:

If when you place the sweeper to recharge and the charging indicator light

does NOT illuminate, then press the On/Off button once to turn the sweeper off. The

charging indicator light should now light up.

Note:

Peak performance may only be realized after the unit has been charged and

discharged two (2) or three (3) times.

Important:

To maintain peak performance of your cordless sweeper, it is

recommended that the unit be fully discharged, then completely re-charged at least

once a month.

Caution:

•

Use only the adaptor supplied with the sweeper.

•

Do not clean the sweeper while unit is charging.

•

Do not attempt to remove the battery pack from the unit to charge it.

•

Never attempt to throw the battery pack or unit into a fire or incinerate it.

•

Do not attempt to remove or damage the battery casing.

Fig. 2

Operating Instructions

To close the dust cup container press firmly on the bottom panel until it snaps

back into place. To replace the dust cup, position onto the sweeper power head

and press down firmly until it snaps back into place.

Periodically remove the transparent brush cover on the front of the cordless

sweeper and remove any build up of lint, hair or fiber on the rotating brush. To

remove the cover - grip the cover from the bottom, pull out and upward until the

cover unlocks from the side slots and tabs located on the top of the sweeper.

Carefully cut away threads or hair with scissors. (Fig. 9)

Caution:

Do not accidentally turn unit on while cleaning.

Caution:

Any electronic or electrical appliance should not be stored in or

exposed to areas of high heat or humidity. Do not store your cordless sweeper

close to stoves, radiators, furnaces or in a bathroom or bathing area.

Fig. 9