DOMUS LINE CUBIT TW Installatiehandleiding - Pagina 4

Blader online of download pdf Installatiehandleiding voor {categorie_naam} DOMUS LINE CUBIT TW. DOMUS LINE CUBIT TW 12 pagina's.

INSTALLATION MANUAL

¹ This installation manual contains instructions valid for all configurations

of the SMALLY-CUBIT-QUADRUM device

WARNING

Safety is guaranteed if these instructions are followed and therefore they

must be kept. Installation may require the involvement of qualified

personnel. Before proceeding with installation of the device, ensure that

the environmental conditions are in conformity with and suitable for the

characteristics of the product. Before any operation on the device

disconnect mains power.

CONFIGURATIONS

The installation and operation instructions in this manual are valid for all

configurations of the SMALLY-CUBIT-QUADRUM device, between which

there are some differences. The SMALLY Plus, SMALLY XS Plus, CUBIT Plus

and QUADRUM Plus (Plug & Play) models refer to the configurations of the

devices that have a built-in disconnectable power cable. The SMALLY IP44,

SMALLY XS IP44, CUBIT IP44 and QUADRUM IP44 models refer to the

configurations of the splash-proof devices. The SMALLY TW, SMALLY XS

TW, CUBIT TW and QUADRUM TW (Tunable White) models refer to the

configurations of the devices that have a built-in LED source with dynamic

light colour adjustment. for correct operation of the SMALLY TW, SMALLY

XS TW, CUBIT TW and QUADRUM TW devices they must be connected

exclusively to an adjustment system supplied by DOMUS Line such as

MAGIC BOX, MAGIC TUNE, TOUCH TW, etc., sold separately. For more

detailed information on DOMUS Line Tunable White adjustment system

characteristics and models go to www.domusline.com or contact us.

All of the SMALLY models can also be fitted with hardware for surface

installation. The SP configuration refers to the devices with symmetrical

surface support. The OB configuration refers to the devices with

asymmetrical surface support. The ML configuration refers to devices for

for flush mount installation on 0.7 mm thick (min.) metal surfaces.

FLUSH INSTALLATION ON WOOD PANELS

The SMALLY-CUBIT-QUADRUM collection devices can be flush mounted

either on a pass-through hole or on a closed-end hole in wood panels.

The installation can be carried out with the light power supply cable in both

an axial or radial position with respect to the installation surface. In the

event of a specific requirement a power wire exit hole can nevertheless be

drilled in other positions as long as it does not compromise the integrity of

the wire and/or the connector installed on it.

- To flush mount the device, bore a ø 57mm hole ≥ 12mm deep on the

installation surface and then, if necessary, bore a ø ≥ 8mm exit hole for

the power supply cable as illustrated in figure 1.

- Insert the power supply cable (A) into the hole and then install the light,

applying light pressure until it is completely fitted as illustrated in figure 2.