DOMUS LINE CAPSENS FW Handmatig - Pagina 5

Blader online of download pdf Handmatig voor {categorie_naam} DOMUS LINE CAPSENS FW. DOMUS LINE CAPSENS FW 6 pagina's.
Ook voor DOMUS LINE CAPSENS FW: Installatiehandleiding (17 pagina's)

Pagina afdrukken

INSTALLATION MANUAL

TECHNICAL SPECIFICATIONS

Input voltage:

12–24Vdc

Output voltage:

12–24Vdc

Maximum applicable load:

30W (with 12Vdc power supply)

60W (with 24Vdc power supply)

WARNINGS

Safety is guaranteed is these instructions are followed and therefore

they must be kept. Installation may require qualified personnel to be

involved. Before proceeding with installation of the device ensure that

the environmental conditions are in compliance with and suitable for

the product characteristics. Before any operation on the device remove

mains power.

CAPSENS FW is an electronic capacitive switch designed to be installed

on the back of surfaces such as wood, plastic, glass and other non

metallic materials, both opaque and transparent and a maximum

thickness as indicated on the table in figure 1 and figure 2; the

information is approximate and the sensitivity of CAPSENS FW can

increase or decrease in relation to the composition and characteristics

of the materials. For materials other than those shown on the table

such as, for example, granite, marble and composite materials, we

recommend making a preliminary test prior to installation in order to

ensure that the device works properly. CAPSENS FW must not be

applied on metallic surfaces. CAPSENS FW allows LED devices that

operate at 12Vdc or 24Vdc to be controlled without direct contact

between the hand and the switch but only with the surface under which

it is installed. The area of activation corresponds to a surface of about

ø 50 mm in correspondence to the device.

INSTALLATION:

- CAPSENS FW can be installed directly on the installation surface (figure 1)

or by boring a ø ≥ 50 mm hole as illustrated in figure 2. To anchor it use

the screws (A) or the double sided adhesive (B) included.

- For installations with the cables in an axial position, if necessary bore a

ø ≥ 12mm hole on the installation surface in correspondence to the

cabling as illustrated in the example shown in figure 2.

- In the package an adhesive window (C) that can be applied on the side

opposite the CAPSENS FW installation surface in order to help identify

activation of the switch.

- Connect the CAPSENS FW only to a safe power supply with 12Vdc or

24 Vdc stabilised voltage (sold separately) and with power at least 10%

higher than the total load. For the total load calculation check the plate

data printed on the product label.

- For connection to a 12Vdc power supply (figure 3) insert the CAPSENS FW

input cable (IN) connector (D) to one of the free slots on the distributor (E)

on the secondary cable of the Converter; then connect the CAPSENS FW

output cable (OUT) connector (F) to the MiniPlug (H) distributor cable

connector (G) which has 12 slots for the connection of 12Vdc LED lighting

devices.

- For connection to a 24Vdc power supply (figure 4) an adaptor cable (I) and

the Micro24 (L) distributor provided in the package must be used. Connect

the CAPSENS FW input cable (IN) connector to the adaptor cable (I) and

then to one of the free slots on the distributor (E) on the secondary cable

of the power supply; then connect the CAPSENS FW output cable (OUT)

connector (F) to the Micro24 (L) distributor cable connector (G) which has

10 slots for the connection of 24Vdc LED lighting devices.

- DOMUS Line guarantees the product only if powered with a Converter

supplied by us.