American Standard Portsmouth 9210.030 Montage-/installatie-instructies - Pagina 7

Blader online of download pdf Montage-/installatie-instructies voor {categorie_naam} American Standard Portsmouth 9210.030. American Standard Portsmouth 9210.030 14 pagina's. 30" vanity

Pagina afdrukken
American Standard Portsmouth 9210.030 Montage-/installatie-instructies
PORTSMOUTH™
Spread Lavatory Faucet
with Speed Connect™ Drain
Congratulations on purchasing your
American Standard faucet with
Speed Connect drain, a feature found
onlyon American Standard faucets.
Speed Connect Drain*
• Fewer parts, installs in less time
• Never needs adjustment
• Guaranteed to seal properly the first time, every time.
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
Heplful tips for removing your current drain can be found in the Troubleshooting section of these instructions.
To ensure that your installation proceeds smoothly-please read these instructions carefully
before you begin.
Recommended tools
Screwdriver
1
INSTALL SPOUT
Insert SPOUT (1) and CABLE CONNECTOR (12) through center hole, making sure
the SEAL WASHER (3) is properly seated in the SPOUT ESCUTCHEON (2).
Assemble RUBBER WASHER (4), BRASS WASHER (5) and LOCKNUT (6) onto SPOUT
SHANK (7) from under side of sink . Make sure SPOUT (1) is centered in the mounting
hole and the slot in the BRASS WASHER (5) faces toward the rear of the sink.
Tighten LOCKNUT (6) firmly. Fig. A.
1A
INSTALL VALVE BODY
Place RUBBER RING (9) into ADAPTER (10).
Install LOCKNUT (11) onto VALVE BODY (8).
From under side of mounting surface, install VALVE BODY (8) through valve
mounting holes. Threads of VALVE BODY (8) should extent at least 5/16
of a inch above mounting surface top. Fig. B. Thread ADAPTER (10)
onto VALVE BODY (8) until snug against internal stop. If necessary, adjust
LOCKNUT (11).
Hand tighten LOCKNUT (11) to secure VALVE BODY (8).
Repeat above steps for opposite VALVE BODY (8A).
10
9
5/16'' MIN.
Fig. B.
Installation
Instructions
Channel Locks
Turn off hot and cold water
CAUTION
supplies before beginning.
MOUNTING
SURFACE
11
8
7420.801
7420.821
Series
7415.801
7415.821
Series
Adjustable Wrench
1
10
9
8
11
1
74 15
Certified to comply with ANSI A112.18.1
M 9 6 5 015 R E V. 1. 7
Tubing Cutter
Fig. A.
1
2
3
SLOT
8A
74 2 0
7
4
5
6
12