Baroness LM2700 Technische informatie - Pagina 5

Blader online of download pdf Technische informatie voor {categorie_naam} Baroness LM2700. Baroness LM2700 6 pagina's. Backlapping
Ook voor Baroness LM2700: Technische informatie (5 pagina's)

Pagina afdrukken

Apply the back-lapping paste to the top

of the rotating cutting cylinder using

the long handled brush as shown.

Do not allow the brush to enter too far

into the cutting cylinder as this could

pull the brush into it. Simply allow the

tips of the brush bristles to flick the

rotating cutting cylinder.

Move the brush from side to side

covering the full width of the blades

with paste.

Repeat this several times, reloading the

brush with abrasive paste each time.

After applying the abrasive paste several times to the cutting cylinder, leave it to rotate during which

time the grinding noise should progressively lessen.

With the first cylinder still rotating, move on to the second cutting unit and repeat the process. After

you have applied the cutting paste to the second unit several times, leave this unit to continue rotating.

With the second cylinder still rotating, go back to the first cylinder and turn it off at the motor using the

lever.

Dip the long handled brush into the back-lapping

paste until the brush has a good covering of the

abrasive paste.