American Standard Colony 2740 Series Installatie-instructies
Blader online of download pdf Installatie-instructies voor {categorie_naam} American Standard Colony 2740 Series. American Standard Colony 2740 Series 4 pagina's. 5 x 30 afr whirlpool/bathing pool, integral apron with removable access panel, for above-floor rough installation, high gloss acrylic, shown less all fittings
Ook voor American Standard Colony 2740 Series: Bedienings- en onderhoudshandleiding (10 pagina's)
Pagina afdrukken
COLONY™ 5 x 30 AFR
INTEGRAL APRON WITH
REMOVABLE ACCESS PANEL
FOR ABOVE-FLOOR
ROUGH INSTALLATION
HIGH GLOSS ACRYLIC
SHOWN LESS ALL FITTINGS
7
(178mm)
3/4
C/L OF DRAIN
(19mm)
FINISHED
WALL
SEE FITTING
SPECS FOR
DIMENSIONS
1-1/2 O.D.
TAILPIECE
29-7/8
(759mm)
C/L OF
SUPPLIES
HORIZONTAL TAILPIECE
ABOVE FLOOR OUTLET
1-1/2 (38mm)
OPTIONAL TO
7/8 WATER
FINISHED FLOOR
RETENTION
USUALLY BETWEEN
FLANGE
65 & 78
(3 SIDES)
(1651 & 1981mm)
C/L OF
OVERFLOW
3
(76mm)
TOP OF
DECK
19-1/4
(489mm)
ROUGH
FLOOR
3-3/4
(95mm)
BATH SUPPORT
MATERIAL
GENERAL SPECIFICATIONS FOR 2740 WHIRLPOOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
3
CUBE (FT
)
WHIRLPOOL ELECTRICAL SPECIFICATIONS
SYSTEM I PUMP
GENERAL INSTALLATION INFORMATION
Bath may only be installed in a recess type installation.
Locate studs as required. Insure rough dimensions are proper, plumb and square. For whirlpools, access to pump/motor may be made through
access opening in apron panel. The following procedure must be used for all installations: leveling support stringer should be as indicated. This bath is
not self-supporting and must be supported along it's entire bottom. Support with mortar or grout.
Position bathtub/whirlpool within the recess, check level, front to back, side to side, and shim as necessary.
To secure the tub to wood studs use drywall screws w/washers or roofing nails immediately above the flange of the tub. To secure the tub to steel studs
use 4" drywall screws and flatwashers.
See page 2 for complete installation information.
Caution: Take extra care when driving nails or screws to avoid damaging the tub.
The tile or similar finished floor will be butted against the bottom of the tub apron, also holding the tub in place.
FOR AFTER-SALES SERVICE CALL 1 (800) 442-1902 WEEKDAYS.
752562-100 Rev. H
2740.XXX SERIES
WHIRLPOOL/BATHING POOL
INSTALLATION INSTRUCTIONS
59-7/8
(1521mm)
WATER
RETENTION
FLANGE
(3 SIDES)
(1) AIR VALVE
(6) JETS
C/L OF
SHOWER ARM
FINISHED
WALL
C/L OF
VALVES
C/L OF
12
SPOUT
(305mm)
OPT.
4
TILING
(102mm)
FLANGE
2-1/2
(64mm)
59-7/8 x 29-7/8 x 19-1/4 (1521 x 759 x 489mm)
105 Lbs. (47 Kgs.)
480 Lbs. (216 Kgs.)
45 Gal. (171 L)
38 Gal. (144 L)
20 x 46 (508 x 1168mm )
25-1/2 x 55-1/2(648 x 1410mm )
11-1/2 (292mm)
39 Lbs./Sq.Ft. (188 Kgs./Sq.m)
1.1 HP, 9.9 AMPS,120V.
THANK YOU .. .
for selecting an American Standard bath. Your new bath is shipped
to you after careful inspection. The whirlpool version is completely
assembled with pump, motor, and system piping. All you need to
finish the installation are your selected fittings and electrical
connections for a whirlpool.
To insure maximum performance and pleasure from this product,
14-1/8
(359mm)
please follow the instructions and cautions.
ON/OFF
List of Required Components (not included):
SWITCH
• Drain 1583.470*
PUMP
* see your American Standard Distributor
ACCESS TO PUMP/MOTOR
THROUGH REMOVABLE
FRONT ACCESS PANEL
List of Required Tools and Supplies:
Tools
• Level
• Tape Measure
• Pipe Wrench
• Slip Joint Pliers
• Screw Driver
LEVELING
• Standard
STRINGER
NOT FOR
Woodworking Tools
SUPPORT
• Personal Safety
UNDERSIDE
Equipment
OF DECK
19
• Caulking Gun
(483mm)
GENERAL INSTALLATION INFORMATION
Carefully uncrate and inspect your new bath for any shipping
damage. If such damage is found, report it to your vendor
immediately.
After inspection and during installation, protect the bath from
construction damage. Before installation, and before
enclosing with wallboard, tile, etc., water test the unit and
check for leaks.
If a whirlpool, do not make modifications to the whirlpool system
or remove pump from factory mounting. This could adversely
affect the safety and performance of the whirlpool and void the
warranty. Do not handle or move the whirlpool by the pump,
motor, or piping system.
20.8
Fittings (bath filler, shower arm, etc.) are not provided with the
35.3
bath and must be ordered separately. Framing and enclosing
materials are provided by others.
IMPORTANT:
Water test unit before installation and enclosure!
• Bath Filler*
Supplies
• Nails
• Putty
• Caulking (waterproof)
• 1 x 3 or 2 x 2
• Drop Cloth
• 15 amp GFI
• Cement, Plaster,
© AS America, Inc. 2008
All product names listed herein are trademarks
of AS America, Inc. unless otherwise noted.
Stringers
Outlet
Grout