Da-Lite ACOUSTICAL IMAGER Instructieboek - Pagina 6
Blader online of download pdf Instructieboek voor {categorie_naam} Da-Lite ACOUSTICAL IMAGER. Da-Lite ACOUSTICAL IMAGER 13 pagina's.
Pagina afdrukken
MOUNTING OPTIONS
SATELLITES AND SURROUNDS
On shelves.
ATTACHING THE SHELF STAND TO THE SPEAKER
1. Thread the two conductors through the two holes
in the stand bracket. Make sure to preserve the
proper polarity (+ and - connections) by threading
the positive conductor through the hole on the left
and the negative conductor through the hole on
the right looking at the front of the stand. Push
down on the red speaker terminal and insert the
bare end of the positive wire into the hole under
the red cap. Release the cap and tug gently on the
wire to make sure that the connection is snug.
Follow the same procedure to connect the
negative wire to its terminal.
+
2. Gently pull the slack out of the wire and screw the
shelf stand onto the back of the speaker in two
places, as shown. The shelf stand screws may be
found in Hardware Bag A. Use the larger screw in
the upper screw hole and the smaller screw in the
lower screw hole.
On the wall. Wall brackets are included.
+
–
–
+
–
MOUNTING THE SATELLITES ON OPTIONAL FLOOR STANDS
NOTE: The supplied floor stand adaptors facilitate installation
with a variety of general purpose floor stands available from
many manufacturers. Since different stands will have
different weight capacities and stability characteristics, it is
the customer's responsibility to check with the stand
manufacturer or dealer whether that specific stand is capable
of handling the weight and proportions of these loudspeakers
in a safe and stable manner.
1. The floor stand adaptors are compatible with floor
stands equipped with a 1/4"-20 threaded insert.
2. Thread the two conductors through the two holes
in the floor stand adaptor. Make sure to preserve
the proper polarity (+ and - connections) by
threading the positive conductor through the hole
on the left, and the negative conductor through
the hole on the right looking at the front of the
adaptor. Push down on the red speaker terminal
and insert the bare end of the positive wire into
the hole under the red cap. Release the cap, and
tug gently on the wire to make sure that the
connection is snug. Follow the same procedure to
connect the negative wire to its terminal.
5
+
–
On optional stands.
+
–