ekco EVH Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ekco EVH. ekco EVH 12 pagina's. Headphone amplifier

Pagina afdrukken

IMPORTANT SAFETY INFORMATION

and maintenance instructions in the literature

accompanying this unit.

is symbol indicates that dangerous voltage

constituting a risk of electric shock is present

within this unit.

Read these instructions.

Keep these instructions.

Heed all warnings.

Follow all instructions.

Do not use this apparatus near water.

Clean only as recommended in these instructions.

Do not block any ventilation openings.

Install in accordance with the manufacturer's instructions.

Do not install near any heat sources such as radiators, heat

registers, stoves, or other apparatus(including ampli ers) that

produce heat.

Do not defeat the safety purpose of the polarized or grounding

type plug. A polarized plug has two blades with one wider

than the other. Agrounding type plug has two blades and a

provided for your safety. If the provided plug does not ﬁt into your

outlet, consult an electrician for replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched,

particularly at plugs, convenience receptacles, and the point

where they exit from the apparatus.

Use only attachments/accessories speci ed by the

manufacturer.

Use only with a cart, stand, tripod, bracket, or table

speci ed by the manufacturer, or sold with the

apparatus. When a cart is used, use caution when moving the

cart/apparatus combination to avoid injury from tip-over.

Unplug this apparatus during lightning storms or when unused

for long periods of time.

Refer all servicing to quali ed service personnel. Servicing is

required when the apparatus has been damaged in any way,

such as power-supply cord or plug is damaged, liquid has been

exposed to rain or moisture, dose not operate normally, or has

been dropped.

Warning: To reduce the risk of re or electrical shock, do not

be exposed to dripping and splashing and no object ﬁlled with

liquids such as a vase of ﬂowers should be placed on the product.

No naked ﬂame sources such as candles should be placed on the

product.

Warning:

e Mains plug is used as disconnect shall remain

readily operable.

Caution: Changes or modiﬁcations not expressly approved by the

manufacturer could void the user's authority to operate this device.

is equipment has been tested and found to comply with

the limits for a Class B digitial device, pursuant to part 15 of

protection against harmful interference in a residential

frequency energy and, if not installed and used in accordance

with the instructions, may cause harmful interference to radio

or television reception, which can be determined by tuning the

equipment o and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

Re-orientate or re-locate the receiving antenna. Increase the

separation between the equipment and the receiver. Connect

the equipment into an outlet on a circuit di erent from that

to which the receiver is connected. Consult the dealer or an

experienced radio/TV technician for help.

Mains Supply:

panel. If this voltage does not match the mains voltage in your

area, consult your dealer about converting the unit.

IEC mains plug has been removed. In the rare event that it has

broken, check for any obvious cause before replacing the fuse

220-230V (UK,Korea,etc.)

100-120V (USA,Japan,etc.)

IMPORTANT NOTICE TO UK USERS

e appliance cord is terminated with a UK approved mains

plug ﬁtted with a 5A fuse. If the fuse needs to be replaced, an

ASTA or BSI approved BS1362 fuse rated at 5A must be used. If

you need to change the mains plug, remove the fuse and dispose

of this plug safely immediately after cutting it from the cord.

Connecting a Mains Plug

e wires in the mains lead are

coloured in accordance with

t h e c o d e : Bl u e : N E U T R A L

Brown: LIVE: Green and Yellow:

Earth. As these colours may

not correspond to the coloured

markings identifying the terminals

in your pulg, proceed as follows:

e BLUE wire must be connected to the terminal marked

wire must be connected to the terminal marked with letter L or

coloured BROWN or RED.

e GREEN & YELLOW wire must be connected to the

terminal marked with the letter E or coloured GREEN or

GREEN & YELLOW or marked with the Earth Symbol

Protective earthing terminal.

connected to a mains socket outlet with a protective earthing

connection.

voltages. DO NOT remove covers or dismantle.

BATTERY WARNING:

ere is a risk of re and burns if the batteries are handled

improperly. Do not disassemble, crush, puncture, short external

contacts, or dispose of in ﬁre or water. Do not attempt to open

batteries.

When the handset operation becomes erratic: replace the

batteries with a pair of new batteries of the same type and

construction.

Discard used batteries in accordance with recycling regulations in

force in your area.

Warning:

not be exposed to excessive heat such as sunshine, ﬁre or the like.

T500mAL 250V Slow Blow

T1AL 250V Slow Blow

e apparatus should be

e handset uses two AAA batteries.