American Standard COPELAND 7005.900 Installatie-instructies - Pagina 2
Blader online of download pdf Installatie-instructies voor {categorie_naam} American Standard COPELAND 7005.900. American Standard COPELAND 7005.900 3 pagina's. Deck-mount bath filler
Pagina afdrukken
3
VALVE ASSEMBLY
Install LOCKNUTS (1) and RUBBER WASHERS (2) onto valve shanks.
Push TUBING (3) ends into VALVE (4) side outlets. Insert VALVES (4)
into mounting holes from underside of ledge.
Press TEE (5) onto SPOUT SHANK (6) making certain that the O-RING (7) is
properly seated on SHANK (6). Push COUPLING (8 or 8a) into TEE (5) and
attach to SPOUT SHANK (6) and tighten. For 7005.901 use a 10 mm
(3/8") hex key.
Thread of VALVE BODY (4) should extend at least 5/16 inch above
MOUNTING SURFACE (11). If necessary, adjust LOCKNUT (1).
Place RUBBER RING (10) into ESCUTCHEON ADAPTERS (9) and thread onto
valves until snug against internal stop.
Tighten LOCKNUT (1) to secure VALVE (4) position.
Slide FERRULE (12) and COUPLING NUT (13) to outlet of VALVE (4) and tighten
COUPLING NUT (13) firmly.
Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of
right VALVE using appropriate connector.
5/16'' MIN.
4
INSTALL HANDLES
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. Fig. A. Tighten
STEM SCREW (3) to secure ADAPTER (1).
Align HANDLE BASE (4) and push onto HANDLE ADAPTER (5) until flush
against mounting surface.
Find correct position of LEVER HANDLE (6) by adjusting
male teeth on ADAPTER (1) to female teeth in HANDLE (6).
Tighten SET SCREW (7) with 5/64
5
SERVICE
To change direction of handle:
Turn valve to OFF position
Remove SET SCREW (7) with 5/64" Hex Wrench.
Pull HANDLE (1) "UP" firmly to release from
ADAPTER (3).
Pull HANDLE BASE (6) off DECK ADAPTER (2).
Remove SPRING CLIP (4). Lift STOP WASHER (5),
turn 90˚ and replace. Replace SPRING CLIP (4).
Re-install HANDLE ASSEMBLY.
If spout drips, operate handles several times from
OFF to ON position. Do not force - handles turn only 90˚.
9
10
11
MOUNTING
4
SURFACE
2
1
HEX WRENCH (8) SUPPLIED.
"
9
10
12
HOT
4
3
5
FOR FITTING
LESS SPRAY
8a
6
8
Fig. A.
SPLINE END DOWN
1
7
"
5/64
HEX
6
WRENCH
4
2
11
MOUNTING
SURFACE
9
10
7
6
13
12
8
13
7
3
TOP
90˚
3
5
M 9 6 8 6 3 8 R E V. 1. 1
COLD
4
1
2
5