Dongcheng S1M-FF05-230 Gebruiksaanwijzing - Pagina 6
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dongcheng S1M-FF05-230. Dongcheng S1M-FF05-230 9 pagina's.
Pagina afdrukken
Installing or Removing the Wheel
CAUTION:
Always be sure that the tool is
switched OFF and unplugged before
installing or removing the wheel.
Screw the inner flange onto the spindle.
Press the spindle lock firmly so that
the spindle cannot revolve, then use
the lock nut wrench to secure the inner
flange. Fit the wheel on over the inner
flange and screw the outer flange onto
the spindle. (Fig.2)
Auxiliary Handle
CAUTION:
Always be sure that the auxiliary
handle is installed securely before
operation.
Use auxiliary handle offered during
operation. Screw the auxiliary handle
securely into the hole on the side of
gear housing or on the top of it. (Fig.
3)
Spindle Lock
CAUTION:
Never actuate the spindle when the
spindle is moving. The tool may be
-9-
damaged.
Press the spindle lock to prevent spindle rotation when installing or removing
accessories (e.g. depressed center wheel). (Fig. 4)
Switch Operation
CAUTION:
Before plugging in the tool, always check to see that the switch trigger actuates
properly.
To start the tool, simply pull the switch
trigger. Release the switch trigger to stop.
For continuous operation, pull the switch
trigger and then push in the lock button. To
stop the tool from the locked position, pull
the switch trigger fully, and then release it.
(Fig. 5)
Operation
CAUTION:
Do not force too much on the tool, or it may damage the wheel and cause
personal injuries.
Stop use the tool when the diameter of
the wheel is worn to 150mm for
S1M-FF05-180,
180mm
S1M-FF05-230. Exchange with a new
one, or it may cause danger.
In general, keep the edge of the wheel at an
angle of about 15-30 degrees to the
workpiece surface. (Fig. 6)
During the break-in period with a new wheel,
for
-10-