Astonica 50100041 Gebruiksaanwijzing - Pagina 2

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Astonica 50100041. Astonica 50100041 2 pagina's. La trec 40'' patio table

PARTS & HARDWARE LIST

PART #

Glass Table Top

Connector Ring

Table Leg

Bolt

Lock Washer

Hex Key

Plastic Bolt Caps

Touch Up Paint

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT

1-888-424-3354.

NOTE: This product is intended for residential, non-commercial use.

CAUTION: Do not over tighten fasteners.

DESCRIPTION

QUANTITY

Figure 1

1. (SEE FIGURE 1) Unpack all parts and remove packing material on

non-scratching surface.

2. Place table top (A) upside down on a flat, non-abrasive surface.

CAUTION: Placing table top and legs on a hard surface may scratch

table glass and damage table rim and legs.

NOTE: The plastic fittings inside of the table rim slide. If necessary, adjust the

plastic fittings into the proper position in the corners. If applicable, adjust

the flat plastic supports so they are evenly spaced between the plastic fittings.

3. Slide all four legs (C) into the end cap leg fittings as shown in diagram. Glass

bumper located on the leg should be facing bottom of glass top.

4. Attach the leg-connector bracket (B) to the table legs. Secure using bolts (D)

and lock washers (E).

5. Tighten all bolts (D) using the hex key provided. Each bolt should be tightened

a few revolutions at a time, alternating between bolts in a cross corner (x) fashion.

This will ensure your table is level by placing equal pressure on all bolt joins.

Do not overtighten.

6. Carefully turn the table in the upright position.

7. Place plastic bolt caps (G) over each bolt (D).

NOTE: Retain touch up paint (H) for future use.

ASSEMBLY INSTRUCTIONS

D and E