AmeriGlide Stair Lift Handleiding voor installatie - Pagina 7

Blader online of download pdf Handleiding voor installatie voor {categorie_naam} AmeriGlide Stair Lift. AmeriGlide Stair Lift 15 pagina's. Stair lift

Only secure the

bottom brackets

2 Pull a piece of string taut from the

top of the track to the bottom. Mark

any places where the string is not

parallel with the track. Check the

results by using the string again. Track

and string should now be parallel.

The wall-side of the track may be

pulled down further than the stair-

side of the track on steps with thick

carpeting/pad. Final track adjust-

ment should occur after the unit is

installed.

The track should still move vertically in

the bracket slots for final adjustment.

Slide the track and brackets against the wall or molding. This will

position the track the required 2" from the wall. If there is an

obstruction on the wall; ex: handrail, window sill, etc; the track

will need to be positioned 2" out further than the obstruction.

Temporarily set something under the bottom of the track to raise

it 1/2" – 3/4" off the bottom landing. This will prevent the track

from hitting the floor later when the track brackets are tightened.

NOTE: If your lift has been ordered with the optional

Wide Seat, the track needs to be positioned 3 1/2" from

the wall or obstruction.

11 With bracket resting on step, position track bolt in

upper half of track bracket slot.

12 Starting with the bottom step, screw the

bracket half-way down – remove book – and

finish securely attaching bracket to the step.

13 Securely tighten remaining track brackets

to the steps using provided wood screws.

Ilus1. - Track shown

with sagging area

due to "short" step