DAB ACTIVE DRIVER M/T 2.2 Handleiding voor programmering - Pagina 3

Blader online of download pdf Handleiding voor programmering voor {categorie_naam} DAB ACTIVE DRIVER M/T 2.2. DAB ACTIVE DRIVER M/T 2.2 10 pagina's.

Programming

The DAB ACTIVE DRIVER is easy to program, it is essential that key information about the

DUTY POINT and PUMP are know before attempting to program the unit.

>ESSENTIAL INFORMATION

1. DUTY POINT (Pressure)

2. Rated Current of Pump (not required for AD M/M 1.1)

3. Pump Curve

>>Duty Point is the required pressure the system is required to run at. This is inputted in

(Bar).

>>The rated current of the pump can be located on the compliance plate attached to the

pump, or is listed in the DAB Factory catalogue in the ELECTRICAL DATA table.

This is only relevant when using three phase pumps.

>>The Pump Curve is essential to ensure that the duty point is achievable with the pump

selected.

The settings should be recorded in the ACTIVE DRIVER manual for later reference.

It is essential to READ THE MANUAL before attempting to operate the ACTIVE DRIVER.