Ameristar MONTAGE Majestic Handmatig - Pagina 3

Blader online of download pdf Handmatig voor {categorie_naam} Ameristar MONTAGE Majestic. Ameristar MONTAGE Majestic 4 pagina's. Ornamental steel fence

Pagina afdrukken

3-1 MARK LOCATIONS FOR ENDS, CORNERS & GATES

Using a string line, mark your property's boundary

lines. Based on your worksheet site plan, locate each

point where the fence starts, stops or turns a corner

(including points for gate locations) and mark it with a

stake (Figure 3-1).

Stake End, Corner & Gate Locations

When staking gate post locations, space the opening

between posts (inside post face to inside post face)

according to the following table:

Nominal

3-2 MARK ALL REMAINING POST LOCATIONS

Starting at an end point, run a tape measure along the

ground to the next stopping point, and drive intermedi-

ate stakes at equal intervals of 96¾", plus or minus

½", to mark the locations for your remaining posts.

Note: All measurements must be made along the

ground elevation, regardless of slope. This ensures

the ATF (All Terrain Fence) feature is properly em-

ployed when panels are 'raked' to follow grade (see

Step 3-4).

48-1/2"

95"

www.MontageFence.com

Measure the distance between each end of the line;

drive a stake halfway between the ends. Proceed

from the center stake to the left end, staking every

96¾"; then return to center and repeat the process

as you move toward the right end (Figure 3-2).

Dig post holes at each marking stake (see Figure 3-3).

The exact diameter and depth of the hole may need

to be increased depending on local weather and soil

conditions. Regardless of depth of the hole, post height

(from ground line) should always be set as follows:

Line and corner posts will require four (4) universal

brackets; End posts will require two universal brackets.