Canon PIXMA MP499 Handleiding voor netwerkinstellingen - Pagina 10
Blader online of download pdf Handleiding voor netwerkinstellingen voor {categorie_naam} Canon PIXMA MP499. Canon PIXMA MP499 24 pagina's. Obtaining network key
Ook voor Canon PIXMA MP499: Handleiding voor netwerkinstallatie (17 pagina's), Netwerkhandleiding (22 pagina's), Netwerkhandleiding (16 pagina's), Handmatig (13 pagina's), Handmatig (10 pagina's)
Pagina afdrukken
- 1. Table of Contents
- 2. The Target Access Point Is Not Displayed (Detected) on the Detected Access Points
- 3. Set Printer Ip Address Screen Is Displayed
- 4. The Machine Is Not Displayed (Detected) on the Detected Printers List Screen
- 5. Problems During Network Setup
- 6. Configuring Wireless Lan Settings Manually
- 7. Other Troubleshooting Tips
- 8. Restoring the Machine's Default Lan Settings to Perform Setup Again
6-A
WEP
G
I
1
Enter the network key in WEP Key (F).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
5 or 13 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 10 or 26 characters (digits).
2
Select Key Length (G).
•
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select 128
bit.
3
Select Key Format (H).
•
Select ASCII when the network key is 5 or 13 characters.
Select Hex when it is 10 or 26 characters (digits).
4
Select Key ID (I).
•
When using AirPort, select 1 in the screen.
Selecting other key numbers will disable the connection between the machine and
AirPort.
5
Select Authentication (J), then click OK (K).
Go to .
WPA/WPA2
Disable
F
H
J
K
6-B
WPA/WPA2
L
1
Enter the network key in Passphrase (L).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
between 8 and 63 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 64 characters.
2
Select Dynamic Encryption Type (M), then click OK (N).
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select
AES(Secure Encryption).
•
When the access point is set to operate in IEEE802.11g and IEEE802.11n with TKIP,
communication is established using IEEE802.11g.
•
When the access point is set to operate only in IEEE802.11n with TKIP, a connection
cannot be established. Change the encryption type to something other than TKIP or
change the standard to something other than IEEE802.11n, then configure wireless
LAN settings again.
Go to .
7
The Manual Setup screen returns. Click Connect.
•
After that, follow the on-screen instructions to proceed with settings.
Disable
M
N